Setting Transition Control Block Button Assignments; Setting Flexi Pad Control Block Button Assignments; Setting Utility/Shotbox Control Block Button Assignments - Sony MVS-8000X User Manual

3
Select the target from the four regions.
4
Select the region to assign.
5
Press [Set].
Note
Only regions assigned here can be used for keyframe or
snapshot recall.
If a switcher bank region is not assigned to a region
selection button in the numeric keypad control block, the
Flexi Pad control block cannot be used to recall a snapshot.
To release a region assignment
Select the target button to release, then press [Clear].
To return the region assignment to the default
Press [Default].
Setting the region selection buttons
selected when the [ALL] button is pressed
1
In the Engineering Setup >Panel >Config >10 Key
Region Assign menu (7321.7), press [All Select],
turning it on.
You can also press the [All Select] button in the status
area.
The [All Select] button indicator in the status area
changes to orange, and the system switches to a mode
for assigning region selection buttons to the [ALL]
button.
2
Press the button and set the region.
The regions with the lit button indicators are assigned
to the [ALL] button. The default is all buttons lit.
For regions you do not want to assign to the [ALL]
button, press the corresponding button indication,
turning it off.
Note
Assignment to the [ALL] button is region by region.
Changing the assignment of a region selection button does
not change the regions assigned to the [ALL] button.
Setting Transition Control Block
Button Assignments
Assignment of the buttons on the left in the transition
control block is performed in the Transition Module1
menu (7321.9), and assignment of the buttons on the right
is performed in the Transition Module2 menu (7321.34).
This section describes the operation in the Transition
Module1 menu as an example.
1
In the Engineering Setup >Panel >Config >Link/
Program Button menu (7321.8), press [Transition
Module1].
The Transition Module1 menu (7321.9) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
Press the target button to make an assignment.
4
In the list on the right, select the function to assign.
5
Press [Set].
To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default].
Setting Flexi Pad Control Block
Button Assignments
This sets Flexi Pad control block button assignments.
1
In the Engineering Setup >Panel >Config >Link/
Program Button menu (7321.8), press [Flexi Pad
Module].
The Flexi Pad Module menu (7321.10) appears.
2
In the <Bank Select> group, select the target bank to
set.
3
Press the target button to make an assignment.
4
In the list on the right, select the function to assign.
5
Press [Set].
To release the assignment
Select the target button to release, then press [Clear].
To return the assignment to the default
Press [Default].
Setting Utility/Shotbox Control Block
Button Assignments
You can change the assignments of the mode selection
buttons and keyframe operation buttons in the utility/
shotbox control block.
411