Enabling The Fm Data Port Of The Switcher; Settings Relating To Signal Formats; Setting The Signal Format - Sony MVS-8000X User Manual

2
Select the target switcher to set.
3
Specify a DME.
When selecting a DME on SWR1: To use the 1st
DME, select [DME1] in the <DME> group. To
use the 2nd DME, select [DME2] in the <DME>
group.
When selecting a DME on SWR2: To use the 1st
DME, select [DME3] in the <DME> group. To
use the 2nd DME, select [DME4] in the <DME>
group.
Note
When using the MKS-7470X/7471X, select [DME1] or
[DME3].
When the signal format is 1080P
You can connect up to four MVE-8000A units for SWR1.
When selecting a DME on SWR1, the following
combinations are available, depending on the number of
DMEs connected.
One DME: DME1
Two DMEs: DME1, DME2
Three DMEs: DME1, DME2, DME3
Four DMEs: DME1, DME2, DME3, DME4
On the MVS-7000X, when using both the MKS-7470X/
7471X and MVE-8000A units, the MKS-7470X/7471X
becomes DME1 and the following combinations are
available for the MVE-8000A units.
One MVE-8000A unit: DME3
Two MVE-8000A units: DME3, DME4
Depending on the DME combination, press [DME1] (1st
DME), [DME2] (2nd DME), [DME3] (3rd DME), or
[DME4] (4th DME), turning it on.
On SWR2, the signal format cannot be changed to 1080P.
Enabling the FM Data Port of the
Switcher
When the FM data port is enabled, frame memory data can
be transferred quickly between the switcher and the control
panels.
1
In the Engineering Setup >System >System Config
menu (7312), press [Switcher Assign].
The Switcher Assign menu (7312.2) appears.
2
Select the target switcher to set.
If there is only one switcher on the network, make the
setting only for SWR1 (1st switcher).
3
Press [FM Data Port Enbl], turning it on.
Settings Relating to
Signal Formats
Notes
• After changing signal format settings, always press
[Execute] (or [FC Format Execute] after changing the
format converter signal format) to save the settings.
If you want to cancel the setting changes without saving
them, press [Clear].
• When you press [Execute], some data is lost (such as
frame memory images). If [FC Format Execute] is
pressed, the data is not lost.
Restrictions on signal formats and re-entry
Re-entry restrictions for an M/E on which a selected signal
format can be used depend on whether or not the color
corrector is used.
For details, see "Restrictions on color corrector and M/E
combinations" (page 186).

Setting the Signal Format

Specify the signal format to be handled by each device.
The combinations of signal formats that can be selected are
as follows.
System Field frequency
HD system 50
59.94
50
59.94
23.98
24
25
29.97
50
59.94
SD system 59.94
50
Note
When the MVS-8000X is used with 1080P signal format
or the MVS-7000X is used with multiple formats, software
options are required (see page 400)
1
In the Engineering Setup >System >Format menu
(7313), select the target device to set.
392
Number of effective
scan lines
1080i
1080P
1080PsF
720P
480i
576i
.