Spot Color Adjustment - Sony MVS-8000X User Manual

Y Modify: Adjusts the output levels of the input
luminance signal (Y modify mode).
If [Tint] or [Color Modify] is selected, set the three
regions (Dark, Mid, Bright) in steps 4 to 7.
If [Y Modify] is selected, set the following parameters.
No. Parameter Adjustment
1 White White balance adjustment
2 Black Black balance adjustment
3 Y Lift Curvature of curve
4 Y Dark Position of peak of curve
4
In the <Bound> group, select [Level] and set the
boundary of the regions.
No. Parameter Adjustment
1 Over B Level Luminance level of the Over
Bright point
2 Mid B Level
Luminance level of the Bright/
Middle point
3
Dark Mid Luminance level of the Middle/
Level Dark point
4 Under D Luminance level of the Under
Level Dark point
5
In the <Bound> group, select [Soft] and set the
softness of the boundary of the regions.
No. Parameter Adjustment
1 Over B Soft Degree of softness at Over Bright
point
2 Mid B Soft Degree of softness at Bright/
Middle point
3 Dark Mid Degree of softness at Middle/Dark
Soft point
4 Under D Soft Degree of softness at Under Dark
point
6
In the <Luminance Process Adjust> group, select the
target region (Dark, Mid, Bright) to adjust.
7
Set the following parameters.
In tint mode
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
In color modify mode
No. Parameter Adjustment
1 Luminance Luminance
2 C Gain Chrominance signal gain
No. Parameter
3 Hue Delay
To return the parameters to their default settings
In the <Luminance Process> group, press [Unity].

Spot Color Adjustment

You can change the color of a specified color region to a
different color, without affecting other regions. You can
also mask part of such a region.
Then, you can also make the following corrections for
areas outside the region whose color you have changed.
• Video signal overall gain adjustment
• Luminance signal gain adjustment
• Luminance signal offset adjustment
• Chrominance signal gain adjustment
• Chrominance signal hue adjustment
Adjusting the color of the specified region
(key)
1
Open the CCR >CCR1 >Spot CCR/Output menu
(2416).
2
In the <Spot CCR> group, press [Spot CCR], turning
it on.
3
In the <Auto> group, press [Sample Mark], turning it
on.
Note
When [Sample Mark] is selected, adjustments outside
the region of spot color adjustment (see page 192) and
output video process effects (see page 192) are
temporarily disabled.
Pressing [Sample Mark], turning it off, restores the
former state.
4
Set the following parameters.
Adjust so that the color you want to change is included
within the sample mark range.
No. Parameter
1 Position H
2 Position V
3 Size
5
In the <Auto> group, press [Auto Start] to adjust the
key automatically.
191
Adjustment
Hue delay
Adjustment
Horizontal position
Vertical position
Size