Sony MVS-8000X User Manual page 451

Selecting the processing order of masks
and borders
In the <Mask/Border Process> group of the Engineering
Setup >Switcher >Key/Wipe/FM/CCR menu (7335),
select one of the following.
Mask>Border: Apply the mask effect, then apply the
border effect.
Border>Mask: Apply the border effect, then apply the
mask effect.
Selecting the key priority mode
In the <Key Priority> group of the Engineering Setup
>Switcher >Key/Wipe/FM/CCR menu (7335), select one
of the following.
Normal: The key priority sequence can be set arbitrarily.
Fix: Fixed at the currently set priority sequence.
Note
In DSK mode, [Fix] is set and the sequence cannot be
selected.
Setting the operation mode of the key bus
[XPT HOLD] button
In the <Xpt Hold Mode> group of the Engineering Setup
>Switcher >Key/Wipe/FM/CCR menu (7335), select one
of the following.
Key Disable: The [XPT HOLD] button of the key bus
functions not only as a cross-point hold button, but
also as a key disable button. When the [XPT HOLD]
button is enabled, the key settings, including the cross-
point selection information, are not reflected, even
when recalling a snapshot or keyframe effect.
Key Dsbl with Status: Same as [Key Disable], but also
disables the reflection of the key on/off status.
Xpt Hold: The [XPT HOLD] button of the key bus
functions as a cross-point hold button. When the [XPT
HOLD] button is enabled, the cross-point selection
information in not reflected, even when recalling a
snapshot or keyframe effect.
Note
This setting is valid for the attributes of snapshots as well
as the operation mode of the [XPT HOLD] button.
To change cross-point hold attributes of a
snapshot
When [Key Disable] is selected, key disable is also applied
to the cross-point hold attributes.
When [Key Dsbl with Status] is selected, the key disable
function is applied, including the key on/off status.
Setting the operation mode when the
pattern limit is released
In the <Pattern Limit Transition> group of the Engineering
Setup >Switcher >Key/Wipe/FM/CCR menu (7335),
select one of the following.
Auto: When the pattern limit is released, the remainder of
the transition is executed automatically at a dedicated
transition rate.
Manual: After the pattern limit is released, the transition
waits for the next operation, then executes. Until you
move the fader lever or press the [AUTO TRANS]
button, the transition is not executed.
Setting the default wipe edge softness
1
In the Engineering Setup >Switcher >Key/Wipe/FM/
CCR menu (7335), press [Wipe Edge Default], turning
it on.
2
Set the following parameter.
No. Parameter Adjustment
3 Soft
Enabling selection of all signals for color
corrector input
You can select signals generated internally in the switcher
as material for input to the color corrector.
To enable, in the Engineering Setup >Switcher >Key/
Wipe/FM/CCR menu (7335), press [CCR Intrnl Signl
Enbl], turning it on.
Note
When you select an M/E re-entry signal as material for
input to the color corrector, a 1H delay occurs to the M/E
output signal.
449
Default value of wipe edge softness