Assigning A Function To A Memory Recall Button In The Utility/Shotbox Control Block - Sony MVS-8000X User Manual

Command name
Pre Macro
Post Macro
Macro Take
Macro Cancel
Macro Auto Ins
Macro AT with Rate
Macro AT with A/B Bus
Macro TL with Region
DME Override
DME Graphic
FTB
Inhibit Set
Inhibit All Clear
SWR1 LAN Status
SWR2 LAN Status
a) The safe title enable/disable commands display the name of the signal
assigned to the output.
b) Control LAN status only.
Assigning a Function to a Memory
Recall Button in the Utility/Shotbox
Control Block
1
In the Engineering Setup >Panel >Prefs/Utility menu
(7324), press [Utility Module Assign].
The Utility Module Assign menu (7324.1) appears.
2
Select the target button to set.
No. Parameter Adjustment
1 Bank Bank selection
2 Button No Memory recall button selection
Function
Sets macro attachment in pre macro
mode.
Sets macro attachment in post macro
mode.
Macro execution
Macro cancel
Macro auto insert mode enable/disable Enabled
Mode enable/disable for storing
transition rate when registering an
auto transition macro event
Mode enable/disable for storing A/B
bus cross-points when registering an
auto transition macro event on the
transition control block
Mode enable disable for saving target
regions when registering a timeline
macro event
DME override enable/disable
DME graphics enable/disable
(applies to graphics for channel
selected in device control block)
Fade-to-black execution
Inhibit cross-point button
Clear all cross-point button inhibit
settings
SWR1 communications status
SWR2 communications status
3
4
421
Button state
Lit amber
Can be set only while
pressed (lit)
Can be set only while
pressed (lit)
Pause during
execution
Lit only at the instant
the button is pressed
Enabled
Enabled
Enabled
Enabled
Enabled
Executing
Can be set only while
pressed (lit)
Can be set only while
pressed (lit)
b)
Communication
s disconnected
b)
Communication
s disconnected
In the <Action> group, select the function to assign.
Menu Shortcut: Assign a frequently used menu to be
recalled (menu shortcut).
Utility Command: Assign a function setting (utility
command).
Macro Recall: Assign a macro register recall.
Shotbox Recall: Assign a shotbox register recall.
Perform the following operations, according to the
selection in step 3.
When [Menu Shortcut] is selected: When the
memory recall button on the utility/shotbox
control block is blinking, display the shortcut
menu. Press the target memory recall button to set
to assign a shortcut. When finished, press [Menu
Shortcut] again.
When [Utility Command] is selected: Select a
command to assign in the list on the right side of
the status area.
Off
Function assigned
Function assigned
Function assigned
Function assigned
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Function assigned
Function assigned
Function assigned
During
communicatio
n
During
communicatio
n