Key Snapshots; Key Snapshot Operations - Sony MVS-8000X User Manual

Key Snapshots

Key settings, other than the key on/off status and the key
priority, can all be instantaneously saved in a dedicated
register and recalled when required. A key snapshot
comprises three values: a cross-point button number, key
memory full mode, and independent key transition, and
can be recalled in any combination.
There are four key snapshot registers for each keyer.

Key Snapshot Operations

You perform key snapshot operations in the Flexi Pad
control block.
Pressing the [KEY] button in the Flexi Pad control block
switches the memory recall section to key operation mode
for saving and recalling key snapshots.
This section describes operation of key snapshots on key 1
on the M/E-1 bank as an example.
KEY button
Key 1 to 8 delegation buttons
Register 1 to 4 selection buttons
Memory recall section
Flexi Pad control block
Button display in the memory recall section
You press buttons in the memory recall section to select
registers (1 to 4).
The register name is displayed on buttons for registers with
a registered snapshot.
The button color varies as follows, according to the
register state.
Dark blue and gray characters: Register not containing
a saved snapshot
Dark blue and white characters: Register containing a
saved snapshot
Lit orange: Last recalled register
Saving a key snapshot
1
In the M/E-1 bank Flexi Pad control block, press the
[KEY] button.
This switches the memory recall section to key
operation mode.
2
Press the [KEY1] button in the memory recall section.
3
While pressing the [KEY] button, press the button for
the register you want to save.
The selected button is lit orange, and the key snapshot
is saved.
Note
If you press a button in which a key snapshot is already
saved, the existing contents of the register will be
overwritten.
Recalling a key snapshot
1
In the M/E-1 bank Flexi Pad control block, press the
[KEY] button.
This switches the memory recall section to key
operation mode.
2
Press the [KEY1] button in the memory recall section.
3
Press the button for the register you want to recall.
The selected button is lit orange, and the key snapshot
is recalled.
The recalled information varies depending on the
settings in the Snapshot >Key Snapshot >Attribute
menu (6351) (see page 338).
124