Sony MVS-8000X User Manual page 469

No. Parameter Adjustment
3 Delay Response field (number of fields)
9
Press [Delay Set].
10
Repeat steps 4 to 9 as required to set other commands.
Configuring detailed settings for a VTR
1
In the <DCU Select> group of the Engineering Setup
>DCU >Serial Port Assign menu (7355), select the
target to set (DCU1 or DCU2).
2
Select the serial port connected to the target VTR to
set.
3
Press [Port Setting].
The VTR Setting menu (7355.2) appears.
The target serial port, slot number, device type, serial
port name, PNL number, and timecode source appear
at the top of the status area. The VTR constants appear
at the bottom of the status area.
4
In the <TC Source> group, select the timecode source
(reference signal for determining the tape position).
LTC: Use LTC (Longitudinal Time Code). When
interpolation data is returned from a VTR, use that
interpolation data.
LTC:VITC: Normally use LTC, except when the tape
is moving at speeds at which LTC cannot be read,
use VITC (Vertical Interval Time Code). When
interpolation data is returned from a VTR, use that
interpolation data.
VITC: Use VITC (Vertical Interval Time Code).
CTL: Use CTL (Control) pulse or timer counter pulse.
Use this only for a tape on which no timecode is
recorded.
The displayed tape position is based on the reference
signal specified here.
5
Select the target item to set.
Block Byte
BLOCK 1
1
2
3
4
5
6
7
8
BLOCK 1
2
2
3
4
5
6
7
8
6
Press [Set].
A numeric keypad window for hexadecimal input
appears.
7
Set the VTR constants using values in the range 00 to
FF.
8
Press [Enter].
9
Repeat steps 5 to 8 as required to make the settings for
other items.
Configuring detailed settings for a disk
recorder (video disk communications
protocol)
1
In the <DCU Select> group of the Engineering Setup
>DCU >Serial Port Assign menu (7355), select the
target to set (DCU1 or DCU2).
2
Select the serial port connected to the target disk
recorder to set.
3
Press [Port Setting].
When "DDR VDCP" is selected as the device type, the
DDR VDCP Setting menu (7355.4) appears.
When "Simple VDCP" is selected as the device type,
the Simple VDCP Setting menu (7355.6) appears.
4
In the <DDR Type> group, select the type of disk
recorder.
467
Item
HI-BYTE (DEVICE TYPE)
LO-BYTE (DEVICE TYPE)
HI-BYTE (FRAME) (PREROLL
TIME)
LO-BYTE (FRAME) (PREROLL
TIME)
EDIT DELAY (FRAME)
EE DELAY (FRAME)
OVER RUN (FRAME)
TRAJECTORY
TC READ DELAY (FRAME)
START DELAY (FRAME)
AFTER SYNC DELAY –
AFTER SYNC DELAY +
MODE1
MODE2
MAX PRRL SPEED
QUICK PVW PRRL TIME (FRAME)