Setting Cross-Point Button Rows In The Cross-Point Control Block; Setting The Operation Mode Of A Button Row; Setting Buttons And Indicators - Sony XVS-G1 User Manual

Setting Cross-Point
Button Rows in the
Cross-Point Control
Block
Setting the Operation Mode of a
Button Row
You can set the operation mode of a cross-point button row
in the cross-point control block.
For details about operation modes, see "Operation Mode
of Cross-Point Button Rows" (page 47).
Note
When a switcher bank is shared on main and sub in multi
program 2 mode, the operation mode of main and sub
button rows are linked.
1
Open the Home > Setup > Panel > Xpt Module >
Operation Mode menu (19104.31).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
3
In the [Row Mode] group, select an operation mode.
Key Bus: Key bus mode
Free Assign: Free assign mode
Key Deleg/AUX: Key/AUX bus delegation mode
Setting a button row in free assign mode
In free assign mode, you can assign a bus or utility/shotbox
mode bank to the 1st row to 4th row.
Note
You can also set the 1st row to 4th row using delegation
buttons assigned to the function button section.
For details about function buttons, see "Cross-Point
Control Block" (page 15).
1
Open the Home > Setup > Panel > Xpt Module > Free
Assign menu (19104.32).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
A list of button rows is shown on the left and a list of
assignable buses/banks is shown on the right.
3
In the list on the left, select the target button row (1 to
4) to set.
4
In the list on the right, select a bus/bank to assign.
5
Press the [Set] button.
To return the assignment to the defaults
Press the [Default Recall] button, check the message, then
press [OK].
Setting the key/AUX bus delegation mode
button row
You can assign bus or utility/shotbox mode bank
delegation buttons to the 1st row in key/AUX bus
delegation mode.
1
Open the Home > Setup > Panel > Xpt Module > Key
Deleg/AUX Assign menu (19104.33).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
A list of 1st row button numbers is shown on the left
and a list of assignable buses/banks is shown on the
right.
3
In the list on the left, select the target button number to
set.
4
In the list on the right, select a bus/bank to assign.
5
Press the [Set] button.
To return the assignment to the default
Press the [Default Recall] button, check the message, then
press [OK].

Setting Buttons and Indicators

Setting the on/off state of cross-point
indicators
Cross-point indicators light up in the source color of the
video signal assigned to buttons on the 3rd row in the
cross-point control block.
You can disable the cross-point indicators so that they do
not turn on.
1
Open the Home > Setup > Panel > Xpt Module >
Operation Mode menu (19104.31).
2
Display the target switcher bank to set.
320