Basic Copy And Swap Operations - Sony MVS-8000X User Manual

Note
On the MVS-8000X, when the signal format is 1080P, the
combinations for a copy or swap are restricted as follows.
• Channels 1 and 2
• Channels 3 and 4
• Channels 5 and 6
• Channels 7 and 8
On the MVS-7000X, when the signal format is 1080P, the
same restriction also applies if using the MVE-8000A.
There is no such restriction if using the MKS-7470X/
7471X.
Copying format converter data
You can copy data between format converter inputs. You
can also copy format converter data between outputs.
Note
The copy source and destination data must be in the same
signal format.

Basic Copy and Swap Operations

Copy/Swap menu
Carry out copy/swap operations in the Copy/Swap menu.
You can select the following targets in the Copy/Swap
>Copy/Swap menu. However, the format converter is
selected in the Copy/Swap >Copy menu.
• M/E: Copying and swapping M/E data
• Key: Copying and swapping key data
• Wipe: Copying and swapping wipe data
• DME Wipe: Copying and swapping DME wipe data
• Matte: Copying and swapping matte data
• Color: Copying and swapping color data
• DME: Copying and swapping data for each DME
channel
• Format Converter: Copying format converter data
For details about color corrector copy and swap, see
"Copy and Swap" (page 187).
Copying or swapping
This section describes copying or swapping wipe data as
an example.
1
Open the Copy/Swap >Copy/Swap >Wipe menu
(3113).
The status area shows lists for the copy/swap source on
the left, and the copy/swap destination on the right.
2
In the <Data Select> group, select one of the
following.
Wipe: The operation applies to wipes in the transition
control block.
Key Wipe: The operation applies to independent key
wipes in the transition control block.
3
Select data for the copy/swap source and copy/swap
destination
4
Press [Copy] to copy, or [Swap] to swap.
To undo a copy or swap
Press [Undo] to return to the state before the copy or swap
was carried out.
Coping using button operation
You can carry out the following copy using button
operations on the control panel.
Copy Using buttons
M/E copy [SNAPSHOT] button on the Flexi Pad
control block
Keyer copy Copy source selection: [KEY1] to
[KEY8] delegation buttons on the key
control block
Copy destination selection: [KEY1] to
[KEY8] key operation buttons on the
Flexi Pad control block
Wipe copy [WIPE] button on the Flexi Pad control
block
DME wipe copy [DME WIPE] button on the Flexi Pad
control block
Basic button operation
Press and hold the copy source button and press the copy
destination button.
You can undo the last operation using [Undo] in the Copy/
Swap menu (see page 179).
Example: Copying key 1 on the M/E-1 bank to key
2 on the M/E-2 bank
1
Press the [M/E1] button in the key control block,
assigning the M/E-1 bank.
2
Press the [KEY] button in the M/E-2 bank Flexi Pad
control block to switch to key operation mode.
3
Press and hold the [KEY1] button in the key control
block and press the [KEY2] button in the Flexi Pad
control block.
179