Renaming Files; Deleting Files - Sony MVS-8000X User Manual

• After step 3, select the data type to display using the
buttons above the list.
Still: Still image files
Clip: Clip files
Ext Clip: Extended clip files
All: All file types

Renaming Files

You can rename files on the local drive or a removable
drive, and rename registers.
This section describes renaming a snapshot file as an
example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
Press [File Edit].
The File Edit menu (7131.1) appears.
You can also select a device and specify a directory in
this menu (see page 379).
3
Select the file to rename.
4
Press [Rename].
5
Enter a name of up to 8 characters in the keyboard
window, and press [Enter].
Note
• Within the switcher, the names for Initial Status and
Setup data are reserved.
You can rename files on the local drive or removable
drive, but reloading will revert files to the default
names.
• The following names cannot be used.
CON, PRN, AUX, CLOCK$, NUL
COM0, COM1, COM2, COM3, COM4, COM5,
COM6, COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6,
LPT7, LPT8, LPT9
Renaming frame memory files
Notes
• In a still image file saved in the 1080P signal format,
there are two still image files for each frame image.
When a register is selected for the operation, renaming
one of the files will automatically rename the other
paired file.
• When a device other than a register is selected for the
operation, renaming one file does not automatically
rename the other paired file. Except for the 'A' or 'B'
suffix in the file name, both files must be renamed
manually to maintain pairing.
Ex: img111A and img111B (underlined portions must
have the same file name)
1
Open the File >Frame Memory >Frame Memory
menu (7151).
2
Press [File Edit].
3
Select the data type to display using the buttons above
the list.
Still: Still image files
Clip: Clip files
Ext Clip: Extended clip files
All: All file types
4
Select the file to rename.
When [Clip] or [Ext Clip] is selected in step 3, you
cannot select more than one file.
5
Press [Rename].
6
Depending on the selections of steps 3 and 4, enter a
name in the keyboard window as follows and press
[Enter].
• When a single file is selected with [Still] or [All]: Up
to eight characters.
• When more than one file is selected with [Still] or
[All]: Up to four characters.
• When [Clip] or [Ext Clip] is selected: Up to four
characters.
Notes
• When [Register] is selected in the device selection
area and more than one file is selected with [Still] or
[All], renaming the files converts the still images to
a clip.
• It is not possible to simultaneously select a file for
which the Ext field in the status area is blank and a
file for which the Ext field shows "Ext" to rename
the files.
• When the signal format is 1080P, a still image file
name is limited to up to seven characters.

Deleting Files

You can delete data from the local drive or a removable
drive, and delete register data.
This section describes deleting a snapshot file as an
example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
Press [File Edit].
382