Secondary Color Correction; Primary Color Correction - Sony MVS-8000X User Manual

To return the parameters to their default settings
In the <Primary CCR> group, press [Unity].
Masking a part of the primary color
correction
This section describes mask 1 as an example. The
operation for mask 2 is identical.
Note
The mask function is common to the primary color
correction, secondary color correction, and spot color
adjustment functions.
1
In the CCR >CCR1 >Primary CCR menu (2412), press
[Mask], turning it on.
2
In the <Primary/Secondary Mask> group, press
[Mask1], turning it on.
Note
If [Mask 2] was selected in the CCR >CCR1
>Secondary CCR menu (2413), [Mask 2] changes to
[Mask 1] in combination with this setting.
3
Press [Mask1 Adjust].
The Mask1 Adjust menu (2412.1) appears.
4
In the <Mask Source> group, select the mask source.
Box: Signal from dedicated box generator
Pattern: Signal from dedicated pattern generator
5
Depending on the selection in step 3, set the following
parameters.
When [Box] is selected
No. Parameter Adjustment
1 Top Position of top side
2 Left Position of left side
3 Right Position of right side
4 Bottom Position of bottom side
5 Soft Degree of softness of box
When [Pattern] is selected
No. Parameter Adjustment
1 Size Pattern size
2 Soft Degree of softness of pattern
edge
5 Pattern Pattern number
a) The patterns are the same as standard wipe patterns 1 to 24.
You can also make a pattern selection by pressing
[Mask Ptn Select] in the Mask1 Adjust menu to
display the Mix Ptn Select menu (2412.2).
Press the desired pattern (1 to 24) to select it, and set
the [Size] and [Soft] parameters.
6
When a pattern is selected as a mask source, set the
pattern modifiers as required.
When selecting [Position] and setting the pattern
position
No.
1
2
a) See page 130.
When selecting [Multi] and replicating the pattern
No.
1
2
3
a) See page 132.
When selecting [Aspect] and adjusting the pattern
aspect ratio
No.
1
a) See page 131.
When selecting [Angle] in the <Rotation> group
and slanting the pattern
No.
1
a) See page 131.
When selecting [Speed] in the <Rotation> group
and rotating the pattern at a constant speed
No.
1
a) See page 131.
7
To invert the mask source, press [Pri/Sec Mask Invrt]
in the Primary CCR menu (2412), turning it on.
a)

Secondary Color Correction

For the six colors R (red), G (green), B (blue), Y (yellow),
C (cyan), and M (magenta), adjust the luminance and
189
Parameter Adjustment
Position H Horizontal position
Position V Vertical position
Parameter Adjustment
H Multi Number of repetitions of pattern
horizontally
V Multi
Number of repetitions of pattern
vertically
Invert Type Replication layout
Parameter Adjustment
a)
Aspect ratio
Aspect
Parameter Adjustment
Rotation angle of pattern
Angle
Parameter Adjustment
Speed Rotation speed of pattern
a)
a)
a)
a)
a)