Saving Files Loaded By Autoload - Sony MVS-8000X User Manual

For details, see "Copying Files Between Different Unit
IDs" (page 387).
Saving Files Loaded by
Autoload
If you save effect setting data, frame memory image files,
and so on in the PWON_LD directory on the local drive,
then when the system is powered on this data is loaded
automatically. This is known as the autoload function.
To save the data to be loaded by the autoload function, use
the menu for operations on individual files.
For details about the data loaded by the autoload function,
see "Saving data loaded by autoload" (page 377).
For details about autoload settings, see "Setting
Automatic Loading of Register Data at Power On
(Autoload Function)" (page 398).
This section describes saving snapshot data as an example.
1
Open the File >Snapshot >Snapshot menu (7131).
2
In the device selection area in the list on the left, select
[Register].
3
In the device selection area on the right, select [Local
Drive].
Be sure to select [Local Drive] as the save destination.
4
Select the [PWON_LD] directory.
The PWON_LD directory is automatically created
when [Power On File Load] is enabled in the
Engineering Setup >System >Start Up menu (7314). If
disabled, the directory does not appear.
5
Select the register to save and the destination file in
which to save it.
You can select more than one register.
To select all registers, press [ALL].
6
Press [t Save].
The data from the selected registers is saved.
If the specified destination already contains data, a
confirmation message appears. Select [Yes] to
overwrite the existing data.
388