Setting Dme Gpi Outputs - Sony MVS-8000X User Manual

• When the DME is an MKS-7470X/7471X, "Format" is
disabled.
Configuring level settings
Configure the settings for low level and high level when
the trigger type is set to "Level."
1
In the Engineering Setup >DME >Device Interface
>DME1 GPI Input menu (7344.1), select an action and
press [H/L Set].
The H/L Set menu (7344.2) appears.
2
Select the setting.
No. Parameter Adjustment
1 No Selection of setting for action
3
To trigger an action when the input is high level or low
level, press [H Set] or [L Set], respectively.

Setting DME GPI Outputs

Set the GPI output port and trigger polarity, and configure
action settings.
Note
On the MVE-8000A, when GPI outputs are set, the Ch1/
Ch2 settings apply to DME1/DME3, and the Ch3/Ch4
settings apply to DME2/DME4.
1
In the Engineering Setup >DME >Device Interface
menu (7344), press [DME1 GPI Output].
The DME1 GPI Output menu (7344.3) appears.
The output port is fixed to number 1.
2
In the <Trigger Type> group, select the trigger
polarity.
Status: The relay opens/closes or the output goes
high/low level in response to the status.
No Operation: The trigger has no effect on the relay
state or the output level.
3
Select the action to set.
You can select Error Make, Error Break, or No Action.
4
Press [Action Set].
460