Wind Settings - Sony MVS-8000X User Manual

Erasing the afterimages that remain in
memory whenever a keyframe is passed
In the DME >Light/Trail >KF Strobe menu (4154), press
[KF Strobe Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
To turn the afterimage portion into
stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >KF Strobe menu (4154),
press [Dust], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 KF Strobe Amount of the afterimage
Dust disappearing as stardust
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
4 Aspect ratio of stardust
Dust
Aspect
a) The way in which the afterimage disappears is affected by both the
keyframe strobe Decay and KF Strobe Dust parameter adjustments.
Disabling the keyframe strobe afterimage
In the DME >Light/Trail >KF Strobe menu (4154), press
[KF Strobe Disable], turning it on.
If this function is enabled when creating a keyframe, even
as the effect passes a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or
after the combine.
Notes
• The combine process function is not supported on the
MVE-8000A.
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Keyframe Strobe
effect only is applied, regardless of the selection in the
<Combine Process> group.
In the <Combine Process> group of the DME >Light/Trail
>KF Strobe menu (4154), select one of the following.
Combine > KF STRB: Add the Keyframe Strobe effect
after the combine.
The parameter data for the channel with the lowest
number among the channels being combined is
enabled.
KF STRB > Combine: Add the Keyframe Strobe effect
before the combine.
Parameters can be set independently for each channel.

Wind Settings

Notes
• The wind function is not supported on the MVE-8000A.
• Enabling Wind automatically disables Trail, Motion
Decay, or Keyframe Strobe if it is set.
Applying the Wind effect
1
Open the DME >Light/Trail >Wind menu (4155).
2
Press [Wind], turning it on.
a)
3
Set the following parameters.
No. Parameter Adjustment
1 Decay
2 Shift H
3 Shift V
a) 0.00 represents no afterimage. 100.00 represents no decay in the
afterimage.
Selecting the signal for the afterimage
portion
In the <Wind Source> group of the DME >Light/Trail
>Wind menu (4155), select the image to insert in the
afterimage trail.
Notes
• Only [Mix Color] or [Ext Video] can be used between
the Background (see page 272), Flex Shadow (see
page 233), Trail (see page 261), and Wind effects. If
[Mix Color] or [Ext Video] is selected for one of these
effects, the [Mix Color] or [Ext Video] for the other
effects is disabled, and [Flat Color] is selected in its
place.
• When executing a 4-channel combination, [Mix Color]
and [Ext Video] cannot be selected.
Freeze Video: Freeze the input image to use as the
afterimage.
Flat Color: Uses a single color matte as the afterimage.
You can set the following parameters.
264
Amount of afterimage displayed
Extension in the horizontal
direction
Extension in the vertical direction
a)