Sony MVS-8000X User Manual page 279

If the Mix1 setting is set to 70, the proportion of the
channels in the mixed portion in the previous illustration is
as shown in the following table.
Combination Color in figure
Ch1 and Ch2
Mix of Ch1, Ch2, and Ch3
If the Mix1 setting is set to 70 and the Mix2 setting is set
to 40, the proportions of the channels in the mixed portions
in the previous illustration are as shown in the following
table.
Combination
Color in
figure
Ch1 and Ch2
Ch2 and Ch3
Ch1 and Ch3
Ch1, Ch2, and
Ch3
Mix of Ch1 and Ch2 / mix of Ch3 and Ch4
If the Mix1 setting is set to 70 and the Mix2 setting is set
to 40, the proportions of the channels in the mixed portions
in the previous illustration are as shown in the following
table.
Combination Color in Ch1
figure
Ch1 and Ch2 30%
–
Ch3 and Ch4
Ch1 crossed with Ch2
Ch1 Ch2
30% 70%
Ch1 Ch2 Ch3
–
30% 70%
–
60% 40%
–
30% 70%
30% 42% 28%
Ch2 Ch3 Ch4
– –
70%
–
60% 40%
Setting the combiner
The setup menu varies depending on the combiner usage
status.
This section describes "Ch1+Ch2+Ch3" and "Ch1+Ch2,
Ch3+Ch4" as examples.
For details about operating procedures when using an SDI
interface, see "Combine operation when using an SDI
interface" (page 279).
1
Open the Global Effect >Ch1-Ch4 >Combiner Priority
menu (4211).
2
Disable [Mix], [Auto], and [Depth], if enabled.
Press [Mix], [Auto], and [Depth], as required, turning
them off.
3
Carry out the following operation, depending on the
type of combination.
For "Ch1+Ch2+Ch3"
In the <Priority1> to <Priority3> groups, press [Ch1],
[Ch2], and [Ch3], respectively, to set the overlap
priority.
Priority1: Select the channel with the highest priority.
Priority2: Select the channel with the second highest
priority.
Priority3: Select the channel with the lowest priority.
Priority1: Ch1
Priority2: Ch2
Priority3: Ch3
For "Ch1+Ch2, Ch3+Ch4"
Press [Ch1] and [Ch2] in the <Combiner1 Priority1>
and <Combiner1 Priority 2> groups, respectively, and
press [Ch3] and [Ch4] in the <Combiner2 Priority1>
and <Combiner2 Priority2> groups, respectively, to
set the priorities for overlaying the images.
278