Motion Decay Settings - Sony MVS-8000X User Manual

When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Selecting the freeze timing
In the <Trail Freeze Timing> group of the DME >Light/
Trail >Trail menu (4152), select the timing for freezing a
trail.
Frame: Freeze in frame units.
Field: Freeze in field units.
Note
The freeze timing setting is not required when the
following signal formats are being used.
1080P/50, 1080P/59.94, 1080PsF/23.98, 1080PsF/24,
1080PsF/25, 1080PsF/29.97, 720P/50, 720P/59.94
Defocusing the afterimage portion (Defocus)
Note
The function to defocus the trail afterimage portion is not
supported on the MVE-8000A.
1
In the DME >Light/Trail >Trail menu (4152), press
[Defocus], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Defocus V Degree of defocusing of the video
signal
2 Defocus K Degree of defocusing of the key
signal
To turn the afterimage portion into stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >Trail menu (4152), press
[Dust], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Trail Dust Amount of the afterimage
disappearing as stardust
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
4 Dust Aspect Aspect ratio of stardust
a) The way in which the afterimage disappears is affected by both
Decay and Trail Dust parameter adjustments.
Setting a combine process
Select whether to add the Trail effect before or after the
combine.
Notes
• The combine process function is not supported on the
MVE-8000A.
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Trail effect only
is applied, regardless of the selection in the <Combine
Process> group.
In the <Combine Process> group of the DME >Light/Trail
>Trail menu (4152), select one of the following.
Combine > Trail: Add the Trail effect after the combine.
The trail parameter data for the channel with the
lowest number among the channels being combined is
enabled.
Trail > Combine: Add the Trail effect before the
combine. Trails parameters can be set independently
for each channel.
Combine > Trail

Motion Decay Settings

Note
Enabling Motion Decay automatically disables Trail,
Keyframe Strobe, or Wind if it is set.
Blurring image motion
1
Open the DME >Light/Trail >Motion Decay menu
a)
(4153).
2
Press [Motion Decay], turning it on.
3
Set the following parameter.
262
Trail > Combine