Setting The Video Process Memory; Setting Show Key; Setting The Key Auto Drop Function; Automatically Naming When Saving To Frame Memory - Sony MVS-8000X User Manual

1
In the Engineering Setup >Switcher >Key/Wipe/FM/
CCR >Bus CCR/Input CCR/Video Proc menu
(7335.3), select the target AUX bus to set.
Note
When AUX mix transitions are enabled, even-
numbered buses cannot be selected as the target.
2
Press [Bus CCR] to enable the color corrector (Enable)
or disable the color corrector (Disable).
For details about each color corrector function, see
"Setting the Color Corrector for an AUX Bus"
(page 182).

Setting the Video Process Memory

In the Engineering Setup >Switcher >Key/Wipe/FM/CCR
menu (7335) or the Engineering Setup >Switcher >Key/
Wipe/FM/CCR >Bus CCR/Input CCR/Video Proc menu
(7335.3), press [Video Proc Memory], turning it on, to
enable the video process memory.
Note
When [CCR] is selected in the <CCR/Video Proc> group
of the Bus CCR/Input CCR/Video Proc menu (7335.3), the
video process memory cannot be set.

Setting Show Key

1
In the Engineering Setup >Switcher >Key/Wipe/FM/
CCR menu (7335), press [Show Key].
The Show Key menu (7335.1) appears.
2
In the <Show Key Enable> group, select the target
signal to set.
3
To set the time for which "show key" is held, press
[Hold Time].
4
Set the following parameter.
No. Parameter Adjustment
1 Hold Time Show key hold time (frames)

Setting the Key Auto Drop Function

The "key auto drop" function automatically switches off a
particular key when you press a cross-point button in a bus
that outputs the background on the particular switcher
bank.
When the background output bus is in flip-flop mode, this
is always the A bus. In bus-fixed mode, it is either the A
bus or the B bus, depending on the fader lever position.
For details, see "Flip-flop mode and bus fixed mode"
(page 87).
1
In the Engineering Setup >Switcher >Key/Wipe/FM/
CCR menu (7335), press [Key Auto Drop].
The Key Auto Drop menu (7335.2) appears.
2
Press the button for the key you want to turn off
automatically, turning the button on.
Automatically Naming when Saving
to Frame Memory
In the Engineering Setup >Switcher >Key/Wipe/FM/CCR
menu (7335), press [FM Auto Store], turning it on.
Note
When the signal format is 1080P, this function cannot be
used.

Selecting the Bank to Configure

Select the target bank to set, then configure the bank.
No. Parameter Adjustment
1 Bank M/E or P/P target bank selection
Selecting the key memory mode
In the <Key Memory> group of the Engineering Setup
>Switcher >Key/Wipe/FM/CCR menu (7335), select the
mode (Full, Simple, Off).
For details, see "Key Memory" (page 97).
448