Other Key Adjustments - Sony MVS-8000X User Manual

To check DME usage status
You can check the DME operating status in the Status
>DME Status menu (3311) (see page 183).
Assigning a DME output signal as a
monitor signal
Press and hold the [MON] button and press the DME
channel selection button (DME1 to DME8) for the DME
channel to use.
This assigns the selected DME output to DME MON V
and DME MON K.
To check DME assignment status
While the [MON] button is pressed, the lit color of the
[DME1] to [DME8] buttons shows the key assignment
status.
Lit green: Indicates a DME currently being monitored.
Lit amber: Indicates a DME which can be monitored.
Not lit: DME is not assigned.

Other Key Adjustments

Using an external processed key
To select key fill and key source signals for a processed
key keyer on the AUX bus or edit preview bus, press
[PROC KEY].
The [PROC KEY] button is lit amber, and the key fill and
key source signals processed on the currently selected
keyer are assigned to re-entry signals PROC V and PROC
K.
When DME is selected on the keyer, the key fill and key
source signals with DME effect applied are assigned.
Note
You cannot select the PROC V and PROC K signals using
the cross-point buttons of the M/E or PGM/PST bank.
Using frame memory feed
To select key fill and key source signals for a processed
key keyer on the frame memory source buses, press the
[FM FEED] button.
The [FM FEED] button momentarily is lit amber, and the
key fill and key source signals processed on the currently
selected keyer are assigned to the frame memory 1 and 2
buses. The [PROC KEY] button is lit amber
simultaneously.
When DME is selected on the keyer, the key fill and key
source signals with DME effect applied are assigned.
Using the show key function
While the [SHOW KEY] button is pressed, the key source
signal for the processed key appears on the specified
output.
You can also set the show key function so that it is
maintained for a preset time after the [SHOW KEY] button
is pressed.
The show key function output and preset time are
configured in the Setup menu.
For details, see "Setting Show Key" (page 448).
Using auto delegation
To couple the selection of the buttons in the following
control blocks so that the delegation selection switches
automatically in the key control block, press the [AUTO
DELEG] button, turning it on.
• Transition control block: [KEY1] to [KEY8] buttons
• Cross-point Flexi Pad of the cross-point control block:
[1-ROW KEY1] to [1-ROW KEY8] buttons, [2-ROW
KEY1] to [2-ROW KEY8] buttons
• Memory recall section on the Flexi Pad control block
(key operation mode): [KEY1] to [KEY8] buttons
Returning the key adjustment values to
their defaults
Press and hold the key type selection buttons (LUM, LIN,
CRK, PTN) to restore the key adjustment values to their
defaults (see page 97).
Key modify clear
Simultaneously pressing and holding a bank delegation
button (M/E1 to M/E5, P/P) and keyer delegation button
(KEY1 to KEY8) sets the selected key settings to the initial
status settings.
For details about initial status, see "Power-On (Startup)
State Selection" (page 397).
116