Blind Settings; Split Settings - Sony MVS-8000X User Manual

No. Parameter Adjustment
2 Random
Degree of randomness in distance
moved by each block
3 Angle Direction of movement
3
To set the partition method, press [Partition] and set
the following parameters.
No. Parameter Adjustment
1 Width Width of partition
2 Random Degree of randomness in partition
width
3 Angle Partition angle

Blind Settings

You can set the number of rotations by blocks, the
perspective, the width and position of blocks, the direction,
the center position, and other parameters. There are two
modes: Bar and Wedge.
To apply the Blind effect
1
In the <Mode> group of the Non Linear >Blind menu
(4141.10), select the mode.
Bar: Bar mode
Wedge: Wedge mode
2
To make transition settings, press [Transition] and set
the following parameters.
No. Parameter Adjustment
1 Rotation Number of rotations of the blocks
2 Perspective Degree of randomness in distance
moved by each block
3
To set the partition method, press [Partition] and set
the following parameters.
When [Bar] is selected in the <Mode> group
No. Parameter Adjustment
1 Width Width of partition
2 Offset Degree of randomness in partition
width
3 Angle Starting angle of effect
When [Wedge] is selected in the <Mode> group
No. Parameter Adjustment
4 No Width of blocks
5 Phase Partition position
To set the wedge center position
When [Wedge] is selected in the <Mode> group, you can
set the wedge center position.
1
Press [Position].
2
Set the following parameters.
No. Parameter Adjustment
1 H
2 V

Split Settings

You can set the degree to which the image is split, the split
positions, and other parameters.
Applying the Split effect
1
In the <Mode> group of the Non Linear >Split menu
(4141.11), select the partition method.
Single: Leave gaps between splits as-is.
Double: Fill gaps between splits with the same image.
2
Set the following parameters.
No. Parameter Adjustment
1 Transition
H
2 Transition
V
No. Parameter Adjustment
1 Top
2 Left
3 Right
4 Bottom
To set the split position
1
Press [Position].
2
Set the following parameters.
No. Parameter Adjustment
1 H
2 V
252
Center point in horizontal direction
Center point in vertical direction
Parameter group [1/2]
Degree of left and right separation
Degree of top and bottom
separation
Parameter group [2/2]
Offset of top edge
Offset of left edge
Offset of right edge
Offset of bottom edge
Degree of left and right separation
Degree of top and bottom
separation