Shotbox Register Creation; Shotbox Register Creation (Numeric Keypad Control Block) - Sony MVS-8000X User Manual

Shotbox Register
Creation
You can create a shotbox register using the numeric
keypad control block or the menu.
Shotbox Register Creation (Numeric
Keypad Control Block)
When you create a shotbox register in the numeric keypad
control block, you carry out separate operations to save the
snapshot setting data and the effect setting data in the
register.
This section describes configuring the snapshot settings
followed by the effect settings as an example.
Creating a shotbox register
1
In the numeric keypad control block, press the
[SNAPSHOT] button.
The control block switches to snapshot operation
mode, and the [SNAPSHOT] button and [RCALL]
button light amber.
2
Recall the snapshots to save in the shotbox register by
specifying the register number for each region.
For details about the method of operation, see
"Recalling a snapshot" (page 332).
3
Press the [SHOTBOX] button.
The control block switches to shotbox operation mode,
and the [SHOTBOX] button lights amber.
4
Press the [STORE] button, turning it on.
The [SNAPSHOT] button lights green.
If not lit, press the [SNAPSHOT] button, turning it on
green.
Note
When the [STORE] button is lit in shotbox operation
mode, the [SNAPSHOT] button or [EFF] button is lit
green to indicate that an operation is in progress to
save snapshot data or effect data in the shotbox
register.
5
Select the snapshot register region to save using the
region selection buttons.
For details about region selection, see "Region
selection in the numeric keypad control block"
(page 307).
6
Enter the save destination shotbox register number
using the numeric keypad buttons.
For details about selecting a register, see "Register
selection in the numeric keypad control block"
(page 307).
7
Press [ENTER].
The snapshot data is saved in the shotbox register.
The [STORE] button turns off and the [RCALL]
button turns on.
8
Press the [EFF] button.
The control block switches to effect operation mode,
and the [EFF] button lights amber.
9
Recall the effects to save in the shotbox register by
specifying the register number for each region.
For details about the method of operation, see
"Recalling a register" (page 308).
10
Refer to steps 3 to 5 and save the recalled effects data.
In step 4, press the [EFF] button instead of the
[SNAPSHOT] button, turning it on green.
11
Enter the shotbox register number specified in step 6
using the numeric keypad buttons.
12
Press the [ENTER] button.
The effects data is saved in the shotbox register.
The [STORE] button turns off and the [RCALL]
button turns on.
Note
While the [STORE] button is lit, you cannot switch to
another operation mode using the mode selection buttons.
To change the operation mode, press the [RCALL] button
or [SHOTBOX] button to turn the [STORE] button off.
To change the contents of a shotbox register
After recalling the shotbox register, change the contents
and save the register by referring to "Creating a shotbox
register" (page 343).
To check the region saved in a shotbox register
1
While the [SHOTBOX] button is lit, press the
[STORE] button, turning it on.
2
Select the target to check.
344