Setting Transition Control Block Button Assignments; Setting The Assignment Of Macro Operation Buttons; Assigning The Dual Background Bus Mode Switching Function - Sony MVS-8000X User Manual

Notes
Assignment to the [ALL] button is region by region.
Changing the assignment of a region selection button does
not change the regions assigned to the [ALL] button.
Setting Transition Control Block
Button Assignments
There are three separate menus for these settings, for the
left part of the transition control block (Transition
Module1), upper right part (Transition Module2), and
lower right part (Transition Module3).
The following example describes the operation for the left
part (Transition Module1 menu), but operations in the
Transition Module2 and Transition Module3 menus are
similar.
1
In the Panel >Config menu, press [Link/Program
Button].
The Link/Program Button menu appears.
2
Press [Transition Module1].
The Transition Module1 menu appears.
3
Select the bank of the transition control block you
want to set in the <Bank Select> group.
The current assignment of the buttons appears at the
left.
4
Press the transition type selection button for which you
want to change the assignment.
The button you pressed appears in reverse video.
5
Using any of the following methods, select the
function to be assigned, from the list on the right.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter Adjustment
1 Button Selection of
Assign function
6
Press [Set].
The texts on the button illustrations change to reflect
the selection.
To cancel the assignment
Press [Clear].
To make the assignment the default
Press [Default].
Setting the Assignment of Macro
Operation Buttons
Notes
This setting applies to all simple type Flexi Pad control
blocks on the control panel.
To switch the [UNDO] button on a simple type Flexi Pad
control block to a [MCRO] button for macro operation, use
the following procedure.
1
In the Panel >Config >Link/Program Button menu,
press [Flexi Pad Module].
The Flexi Pad Module menu appears.
2
Select the assignment of the [UNDO] button in the
simple type Flexi Pad control block from the <UNDO
Button Assign> group.
UNDO: use as an [UNDO] button.
MACRO: use as a [MCRO] button.
Assigning the Dual Background Bus
Mode Switching Function
The dual background bus mode is a mode in which the
background A row shifted signal can be selected with the
key 1 row, and the background B row shifted signal can be
selected with the key 2 row. To switch this mode on and
off, it is necessary to assign this function to the cross-point
control block [PRE MCRO] button.
For details of the dual background bus, see "Signal
Selection" in Chapter 3 (Volume 1).
1
In the Panel >Config menu, press [Link/Program
Button].
The Link/Program Button menu appears.
Setting values
2
Press [Xpt Module].
1 to maximum
value
The Xpt Module menu appears.
3
Using any of the following methods, select the bank.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Overall Control Panel Settings (Config Menu)
167