Sony MVS-8000X User Manual page 295

KF1 action Operating
setting status of file A
Start Playback
Variable Speed Playing at
set variable speed
Cueup Cueup
- Partial operating limitation:
KF1 action Operating
setting status of file A
Start Playback
Variable Speed Playing at
set variable speed
Cueup Cueup
a) Failure to operate when variable speed is set to minus value.
However, operates when the file B action is set to Start, and then
variable speed is set to minus after file B starts playing.
- Play does not switch from file A to file B:
KF1 action Operating
setting status of file A
Variable Speed Playing at
set variable speed
Cueup Cueup
If play continues to show video of file A without
switching to file B, a Stop action is required in file A
in order to switch to file B.
• When using the Odetics protocol, the variable speed
action may not operate, depending on the connected
device.
VTR/disk recorder/Extended VTR timeline
editing
Set an action at a keyframe point, and edit the timeline.
For details about keyframe creation, see "Creating and
Editing Keyframes" (page 310).
To set an action in the menu
1
Open the Device >DDR/VTR >Timeline menu
(5332).
In the status area, two lists appear. The upper list
shows the device number, register number, keyframe
number, and action type (start point, stop point, and
variable speed) set for the keyframe.
The lower list is used for setting the action for the
device selected in the upper list. This list shows the
port name, current file, current time, status
information, start point, stop point, variable speed, and
file name (for a disk recorder or Extended VTR).
2
Select the device.
KF2 action
setting
3
To set the name of a file when using an Extended VTR
Cueup
or disk recorder, recall the file using the Device
Cueup
>DDR/VTR >File List menu (5333).
Cueup
Notes
• There is a limit of eight disk recorder files that can
set on a single timeline.
KF2 action
• If you have not set the file name when using an
setting
Extended VTR, the file recalled in the Extended
Variable Speed
VTR when the keyframe point is passed is the
a)
set
subject of the action.
Variable Speed
a)
set
4
In the <Action> group, select the action.
Variable Speed
a)
set
Cueup: Output a command to cue up to the currently
Start: Output a Play command.
Note
When the stop point and variable speed are both set,
KF2 action
the variable speed setting takes priority.
setting
Start
Stop: Output a Stop command.
Start
Note
Before executing the Stop command, if the timecode
for the set stop point has been reached, or on an
Extended VTR or disk recorder if the end of the file
has been reached, then at that point the device stops.
5
To set the start point, press [Set] in the <Start TC>
group.
Enter the timecode for the start point in the numeric
keypad window, and press [Enter].
Note
For a disk recorder on which the start point is not set,
the file recalled in the disk recorder when the keyframe
point is passed is the subject of the action.
6
To set the stop point, press [Set] in the <Stop TC>
group.
Enter the timecode for the stop point in the numeric
keypad window, and press [Enter].
7
To set the variable speed, select one of the following
in the <Variable Speed> group.
Fit: Without setting a speed value, automatically carry
294
displayed start point.
out playback according to automatically
calculated values for the duration and keyframe
duration to fit the set start point and stop point.