Saving And Recalling Setup Data; Selecting The Startup State; Saving User-Defined Settings; Setting Automatic Loading Of Register Data At Power On (Autoload Function) - Sony MVS-8000X User Manual

Saving and Recalling Setup Data

Local drive / removable drive
User setup data
Load
File menu:
[Load]
RAM
Current setup data
(If in Resume mode, settings data is saved.)
Save
In Custom mode,
Setup
power on or reset
menu:
[Setup
Define]
Non-volatile memory
User setup data
Updating the switcher or control panel setup data saves the
updated setup data in RAM in each device.
• In Resume mode (see page 397), even if devices are
reset or powered off, the data is preserved in RAM, and
recalled when the power is turned back on.
Note
On DMEs, Resume mode cannot be used.
• In Custom mode (see page 397), the user-defined
settings (user setup data) saved in non-volatile memory
or factory default setup data held in ROM in each device
is recalled when a reset occurs or power is turned back
on.
The setup data in RAM can also be saved to the local drive
or removable drive on the menu panel.

Selecting the Startup State

1
In the Engineering Setup >System >Start Up menu
(7314), select the target device to set.
2
In the <Start Up Mode> group, select the mode.
Resume: Resume mode (see page 397)
Custom: Custom mode (see page 397)
Save
File menu:
[Save]
Initialize
Setup
menu:
[All Clear]
ROM
Factory default setup data
398
Note
[Resume] is enabled only when a switcher or control
panel is selected.
3
When [Custom] is selected, in the <Setup> group or
<Initial Status> group, select one of the following.
User: Set user-defined settings for the Setup or Initial
Status settings.
Factory: Set factory default settings for the Setup or
Initial Status settings.
4
Press [Execute].
5
Check the message, then press [Yes].

Saving User-Defined Settings

1
Open the Engineering Setup >System >Start Up menu
(7314).
2
Select the target device to set, and perform the
following operation.
• To save Setup settings, press [Setup Define].
• To save Initial Status settings, press [Init Status
Define].
3
Check the message, then press [Yes].
For details about settings that are saved, see "Data Saved
by [Setup Define] and [Initial Status Define]" (page 542).
Setting Automatic Loading of
Register Data at Power On (Autoload
Function)
You can set the system to load preset data at startup.
In the Engineering Setup >System >Start Up menu (7314),
press [Power On File Load], turning it on.
When the autoload function is enabled, a directory
"PWON_LD" appears in the File menu.
For details about saving data to load, see "Saving Files
Loaded by Autoload" (page 388).