Snapshot Operations (Menu); Selecting A Region Or Reference Region; Setting Snapshot Attributes - Sony MVS-8000X User Manual

Snapshot Operations
(Menu)
Operations in the Snapshot menu
You use the Snapshot menu to make snapshot settings.
The Snapshot menu displays the status of each register,
and is used to perform operations, such as to set snapshot
attributes or copy/delete snapshot registers.
Operations in the Misc >Snapshot menu on a
switcher bank
You can limit the snapshot setting to M/E or PGM/PST
banks.
Selecting a Region or Reference
Region
During snapshot operations, you can select a region in the
menu. This is convenient for selecting some of the regions
assigned to the numeric keypad control block or when
changing the reference region.
For details about the method of operation, see "Recalling
regions to edit (menu)" (page 309).

Setting Snapshot Attributes

Adding attributes to a snapshot
1
Open the Snapshot >Snapshot >Attribute menu
(6321).
The status area shows the region names, register
numbers and status, and attribute settings.
2
Press the region display in the upper part of the list to
display a selection window, then select the region in
the selection window.
You can select more than one region.
To select all regions, press [ALL]. To select all
switcher-related regions (M/E, P/P, User), press [SWR
ALL].
3
Press [OK].
4
Select a register.
To select all registers, press [ALL]. To select multiple
registers, set the [Num] parameter (see page 327).
5
In the <Attribute> group, select the attribute (see
page 330) you want to add.
Configure the attribute, as required.
To add the cross-point hold attribute
Note
To add key disable to the cross-point hold attribute
requires a setting in the Setup menu.
For details, see "Setting the operation mode of the key bus
[XPT HOLD] button" (page 449).
1
Press [Xpt Hold].
The Xpt Hold menu (6321.1) appears.
The status area shows a list of the currently selected
regions and bus names.
2
Select a bus.
When the region is set to RTR (Router), select a
destination.
To select one or more buses/destinations, press
[Plural] and then select. To select all buses/
destinations, press [ALL].
3
When RTR (Router) is selected for region, press [RTR
Level].
A window appears for selecting the router level.
When RTR (Router) is not selected, skip to step 5.
4
Select the level for the cross-point hold setting, and
press [OK].
To select all levels, press [ALL].
5
In the <Xpt Hold> group, press [ON].
This enables cross-point hold on the selected bus or
buses.
To add the effect dissolve attribute
1
Press [Effect Dissolve], turning it on.
2
Set the dissolve duration.
No. Parameter Adjustment
3 Eff Diss
Duration
To set the duration for an effect dissolve
temporary attribute
To set the duration for an effect dissolve temporary
attribute in the numeric keypad control block or Flexi Pad
control block, set the following parameter.
337
Dissolve duration