Aux Bus Control Block Settings; Setting The Aux Bus Block; Configuring Router Control - Sony MVS-8000X User Manual

AUX Bus Control Block
Settings

Setting the AUX Bus Block

Assigning a bus to an AUX delegation
button
You can assign a bus to the 1st row/2nd row delegation
buttons of the AUX bus control block.
1
Open the Engineering Setup >Panel >Aux Assign
menu (7323).
The left side of the status area shows the delegation
button numbers and the assigned buses, and the right
side shows a list of assignable buses.
2
Select the target button number to set.
3
Selects a bus to assign.
4
Press [Set].
To set the [SHIFT] button operation
In the <Shift Mode> group, select one of the following.
Hold: The bus on the shifted state of the delegation button
is enabled while pressing the [SHIFT] button.
Lock: Pressing the button toggles between the buses on
the shifted and unshifted state of the delegation
buttons.

Configuring Router Control

You can configuration destinations and level selection
buttons in the Router >Router Control >Router Control
menu (5111).
Assigning a destination to a destination
selection button
1
In the Engineering Setup >Panel >Aux Assign menu
(7323), press [RTR Mode Setting].
The RTR Mode Setting menu (7323.1) appears.
The left side of the status area shows the button
numbers, destination names, and source table
numbers. The right side of the status area shows a list
of assignable destinations.
2
Select the target button number to set and the
destination to assign.
To inhibit operation of buttons, press [Inhibit].
Note
When a button with number 65 to 128 is selected, the
source table selection is automatically disabled, and
the [Inhibit] setting is also disabled.
3
Press [Dest Set].
4
When a button with number 1 to 64 is selected in step
2, select the source table.
5
Press [Source Table Set].
6
Repeat steps 2 to 5 as required.
Setting the source table
1
In the Engineering Setup >Panel >Aux Assign >RTR
Mode Setting menu (7323.1), press [Table Assign].
The Table Assign menu (7323.3) appears.
2
In the <Source Table Select> group, select the target
source table to set.
3
Select the target button number to set and the source to
assign.
To inhibit operation of buttons, press [Inhibit].
4
Press [Source Set].
Assigning levels to level selection buttons
1
In the Engineering Setup >Panel >Aux Assign >RTR
Mode Setting menu (7323.1), press [Level Button
Assign].
The Level Button Assign menu (7323.4) appears.
2
In the <Level Button Select> group, select the target
button to set.
3
In the <Level Assign> group, select the level to assign
to the button.
You can select more than one level. You can also
duplicate the selection on another button.
Selecting a destination selection button for
a snapshot
You can set whether snapshots are recalled for each
destination selection button.
417