Sony MVS-8000X User Manual page 269

of two setting values are the same, the effect is the same
even if the integral parts are different.
The integral part of a setting value is used when moving a
light source with keyframes.
For example, when the longitude of a light source rotates in
the clockwise direction from 0.88 (315) to 0.12 (45), it
rotates in the counterclockwise direction (the angle grows
smaller) if the above values are used. In this case, the value
of the second keyframe can be set to 1.12 (360+ 45).
KF2 = 0.12
Test
sphere
Setting the surface where light strikes the
image
1
Open the DME >Light/Trail >Spot Lighting menu
(4156).
2
Press [Spot Lighting], turning it on.
3
Set the following parameter.
You can make the Spot Lighting effect more effective
by adjusting the [Total Ambient] parameter to lower
the brightness of the entire image.
The [Total Ambient] setting is common to the
Lighting function.
No. Parameter Adjustment
1 Brightness of whole image
Total
Ambient
4
In the <Surface Select> group, select the state of the
surface struck by the light.
Flat: The image surface is unchanged. This causes the
selected light source to appear as the effect.
Texture: A texture appears on the surface.
Non Linear: Spotlighting effect is applied to an area
to which a DME nonlinear effect is applied.
Notes
• The BZDM-9050 Texture Lighting Software (for
MVE-9000) is required to enable [Texture] or [Non
• The Spotlighting [Non Linear] setting is effective
5
When [Texture] or [Non Linear] is selected in step 4,
KF1 = 0.88
set the following parameters.
When [Texture] is selected
No.
1
2
KF2 = 1.12
3
4
5
a) Minus moves left, plus moves right.
b) Minus moves down, plus moves up.
c) Plus emphasizes bumps in texture, minus emphasizes depressions.
When [Non Linear] is selected
No.
5
a) Light appears from Z direction. At –100.00 the light is directed
6
When [Texture] is selected in step 4, select a pattern
(see page 268).
7
When [Texture] is selected in step 4, select the way it
is applied in the <Surface Axis> group.
Move: The texture moves together with the DME
Fix: The texture does not move, even if the DME
For details about how it is applied, see "Coordinate
axis on surface of image" (page 265).
When [Non Linear] is selected in step 4, [Fix] is
disabled, if selected, and the behavior is the same as
[Move].
To select a texture pattern
1
In the Spot Lighting menu (4156), press [Texture Ptn
Select].
268
Linear]. An install key must be entered to use the
software.
For details, see "Configuring Settings to Use the
Software" (page 400).
for the following nonlinear effects. For other effects,
the result is the same as selecting [Flat].
Wave, Mosaic Glass, Flag, Ripple, Lens, Panorama,
Page Turn, Roll.
Parameter Adjustment
Movement in X-axis direction
X
Y Movement in Y-axis direction
Size X Image size in X-axis direction
Size Y Image size in Y-axis direction
Amp Emphasize bumps and
depressions
0.00 is a flat surface.
Parameter Adjustment
Amp Light separation distance
toward the rear, at +100.00 the whole image is lit like a flat effect.
image.
image moves.
Note
a)
b)
c)
a)