Sony MVS-8000X User Manual page 416

Set: Delete the signal currently assigned to the
selected button number and make a new
assignment.
Insert: Move the signal currently assigned to the
selected button number to the next number, and
make a new assignment.
Note
When a number of 121 or higher is selected, "Insert"
cannot be executed.
When a signal for a button with number 121 or higher
is changed as a result of executing [Insert], the signal
assigned to number 120 is automatically deleted, and
signals assigned to numbers 121 or higher are
maintained.
To inhibit operation of buttons
Select the target button number to set, and press [Inhibit].
To delete a signal assigned to a button
Select the button number, and press [Delete] in the <Xpt
Assign> group.
The signals assigned to numbers following the selected
button number move up in sequence.
Note
When a button number of 121 or higher is selected,
[Delete] cannot be executed.
When a signal for a button with number 121 or higher is
changed as a result of executing [Delete], the signal
assigned to number 120 is moved to number 119, and
signals assigned to numbers 121 or higher are maintained.
Creating tables 1 to 14
You create tables 1 to 14 in the same way as when creating
the main table, and you can assign the same signal to more
than one button number, or delete currently assigned
signals. However, assignment of video and key
combinations as a pair is not possible.
1
In the Engineering Setup >Panel >Xpt Assign menu
(7322), press [Table Button Assign].
The Table Button Assign menu (7322.1) appears.
The target table number to set appears in the upper left
of the status area.
The left part of the status area shows the cross-point
button numbers, video and key pair numbers, video
signal source names and source numbers, and key
signal source names and source numbers. When the
shift button is pressed, the number field is
distinguished by color.
The right part of the status area shows the video and
key pair numbers, and the names of video signals and
key signals set in the main table.
2
Select the target table to set.
No. Parameter Adjustment
1 Table No
3
Select the target button number to set.
4
Select the pair signal to assign.
5
In the <Button Assign> group, select one of the
following.
Set: Delete the signal currently assigned to the
selected button number and make a new
assignment.
Insert: Move the signal currently assigned to the
selected button number to the next number, and
make a new assignment.
Note
When a number of 121 or higher is selected, "Insert"
cannot be executed.
When a signal for a button with number 121 or higher
is changed as a result of executing [Insert], the signal
assigned to number 120 is automatically deleted, and
signals assigned to numbers 121 or higher are
maintained.
To inhibit operation of buttons
Select the target button number to set, and press [Inhibit].
To delete a signal assigned to a button
Select the button number, and press [Delete] in the
<Button Assign> group.
The signals assigned to numbers following the selected
button number move up in sequence.
Note
When a button number of 121 or higher is selected,
[Delete] cannot be executed.
When a signal for a button with number 121 or higher is
changed as a result of executing [Delete], the signal
assigned to number 120 is moved to number 119, and
signals assigned to numbers 121 or higher are maintained.
Returning a table to defaults
1
In the Engineering Setup >Panel >Xpt Assign >V/K
Pair Assign menu (7322.5) or the Engineering Setup
>Panel >Xpt Assign >Table Button Assign menu
(7322.1), press [Default Recall].
2
Check the message, then press [Yes].
414
Selection of the table to set