Selecting Independent Key Transition Type; Setting The Independent Key Transition Rate - Sony MVS-8000X User Manual

- Wind
When the Keyframe Strobe effect is set, the effects are
equivalent to operation using keyframes. In this case as
well, cancel the unnecessary DME settings.
Selecting Independent Key
Transition Type
There are two ways of setting the transition rate: using the
Flexi Pad control block or using the Transition menu for
the target key on the M/E or PGM/PST bank.
If key insertion/removal is set to another mode in the Setup
menu, it is possible to set a different transition type when
the key is inserted or removed.
Setting the independent key transition
type (Flexi Pad control block)
If key insertion/removal is set to another mode in the Setup
menu, make a setting while a key is not inserted to set the
transition type for insertion, and make a setting while a key
is inserted to set the transition type for removal.
1
In the Flexi Pad control block of the target switcher
bank, press the [KEY] button.
This switches the memory recall section to
independent key mode.
2
Select the target key.
Press one of the [KEY1] to [KEY8] buttons, turning it
on.
3
Set the transition type.
Press the [MIX], [WIPE], or [DME WIPE] button,
turning it on.
Setting the independent key transition
type (menu)
This section describes setting the transition type for key 1
on the M/E-1 bank as an example.
1
Open the M/E-1 >Key1 >Transition menu (1116).
2
Select the transition type in the <Transition Type>
group.
If key insertion/removal is set to another mode in the
Setup menu, select the transition type for insertion in
the <On Transition Type> group and the transition
type for removal in the <Off Transition Type> group.
Setting the Independent Key
Transition Rate
There are two ways of setting the transition rate: entering
a value using the numeric keypad control block or using
the Transition menu for target key on the M/E or PGM/
PST bank.
You can also display the transition rate, independent key
transition rate, and fade-to-black transition rate for each
bank, and change the settings (see page 180).
If key insertion/removal is set to another mode in the Setup
menu, it is possible to set a different transition rate when
the key is inserted or removed.

Setting the independent key transition rate

(utility/shotbox control block and numeric
keypad control block)
If key insertion/removal is set to another mode in the Setup
menu, make a setting while a key is not inserted to set the
transition rate for insertion, and make a setting while a key
is inserted to set the transition rate for removal.
1
Press the [TRANS RATE1] to [TRANS RATE3]
buttons in the utility/shotbox control block.
This switches the memory recall buttons to transition
rate display mode.
For details about the [TRANS RATE1] to [TRANS
RATE3] buttons, see "Setting the transition rate
(utility/shotbox control block and numeric keypad
control block)" (page 82).
2
Press a memory recall button displaying the transition
rate to set for the target key, turning it on.
The region name and transition rate appears in the
numeric keypad control block display.
3
Enter the transition rate using the numeric keypad in
the numeric keypad control block.
You can switch the input mode using the [TC] button.
In frame input mode, enter three digits. In timecode
input mode, enter four digits.
To clear the entered value, press the [CLR] button.
4
Press the [ENTER] button.
The input is applied, and the specified value is
reflected in the memory recall button in the utility/
shotbox control block.
The specified value is also displayed in the
independent key transition display section of the
transition control block.
93