Sony MVS-8000X User Manual page 109

No. Parameter Adjustment
5 Soft Degree of softness of box
When [Pattern] is selected
No. Parameter Adjustment
1 Size Pattern size
2 Soft Degree of softness of pattern edge
5 Pattern Pattern number
a) The patterns are the same as standard wipe patterns 1 to 24.
You can also make a pattern selection by pressing
[Mask Ptn Select] in the Main Mask menu to display
the Mask Ptn Select menu (1113.1).
Press the desired pattern (1 to 24) to select it, and set
the [Size] and [Soft] parameters.
5
To invert the mask source, press [Mask Invert],
turning it on.
6
When a pattern is selected as a mask source, set the
pattern modifiers as required.
When selecting [Position] and setting the pattern
position
No. Parameter Adjustment
1 Position H Horizontal position
2 Position V Vertical position
a) See page 130.
When selecting [Multi] and replicating the pattern
No. Parameter Adjustment
1 H Multi Number of repetitions of pattern
horizontally
2 V Multi Number of repetitions of pattern
vertically
3 Invert Type Replication layout
a) See page 132.
When selecting [Aspect] and adjusting the pattern
aspect ratio
No. Parameter Adjustment
1 Aspect Aspect ratio
a) See page 131.
When selecting [Angle] in the <Rotation> group
and slanting the pattern
No. Parameter Adjustment
1 Angle Rotation angle of pattern
a) See page 131.
Using the sub mask
a)
1
2
3
a)
a)
a)
4
a)
a)
5
108
When selecting [Speed] in the <Rotation> group
and rotating the pattern at a constant speed
No. Parameter Adjustment
1 Speed Rotation speed of pattern
a) See page 131.
Open the M/E-1 >Key1 >Sub Mask menu (1114).
In the <Mask Type> group, select the mask type.
Key Mask: Masks a part of a key.
Bkgd Mask: Masks a part of a background.
In the <Mask Source> group, select the mask source.
Wipe: Wipe pattern selected for a transition.
Press [Pattern Select] to open the M/E-1 >Wipe
>Main Pattern menu (1151), and select a pattern
and set modifiers (see page 125).
Note
In patterns selected for a mask, modifiers for wipe
direction and edges are disabled.
Utility 1 Bus: Signal selected on the utility 1 bus.
On the cross-point control block, press the [1-
ROW UTIL1] button in the cross-point Flexi Pad,
then select a signal using the cross-point buttons in
the 1st row.
Note
You can assign a utility 1 bus delegation button to the
1st row or 2nd row of the AUX bus control block in the
Setup menu (see page 417).
Depending on the selection in step 3, set the following
parameters.
When [Wipe] is selected
No. Parameter Adjustment
1 Size Pattern size
2 Soft Edge softness
When [Utility 1 Bus] is selected
No. Parameter Adjustment
1 Clip Reference level for creating mask
signal
2 Gain Gain
To invert the mask source, press [Mask Invert],
turning it on.
a)