Setting The Ip Converter Conversion Method - Sony MVS-8000X User Manual

Original image (16:9)
To set the image position in edge crop up-
conversion
Set in the same way as for an up-converter (see page 440).
To configure the enhancer
Set in the same way as for an up-converter (see page 440).
Copying format converter input data
1
In the Engineering Setup >Switcher >Input >FC
Adjust menu (7332.2), press [Copy].
The Copy/Swap >Copy >Format Converter menu
(3121) appears.
2
In the <Data Select> group, select [Input].
3
Select the copy source and copy destination data.
4
Press [Copy].
Down-converted image (4:3)
Edge Crop
Letter Box 13:9
Letter Box 14:9
Letter Box 16:9
Squeeze
441
Setting the IP Converter Conversion
Method
This sets the conversion mode for the IP converter input.
Note
Setting the conversion mode for PI converter output is not
required.
1
In the Engineering Setup >Switcher >Input menu
(7332), press [FC Adjust].
The FC Adjust menu (7332.2) appears.
2
Select the target input to set.
3
In the <Conversion> group, select the conversion
mode.
Frame: Conversion in frame units
Field: Conversion in field units
Adaptive Y: Detects motion in the luminance signal,
and automatically switches between conversion
using frame units and field units.
Adaptive Y/C: Detects motion in the luminance and
hue signals, and automatically switches between
conversion using frame units and field units.
When [Adaptive Y] or [Adaptive Y/C] is selected, set
the following parameter.
No. Parameter Adjustment
Motion detection sensitivity
1 Motion
Select
a) 1: Mode with highest proportion converted from frames (still picture
priority mode)
2: Mode with higher proportion converted from frames.
3: Mode with higher proportion converted from fields.
4: Mode with highest proportion converted from fields (motion
priority mode)
a)