Signal Name Display; Transitions; Transition Type - Sony MVS-8000X User Manual

Signal Name Display

You can attach a name (source name) to the signal
assigned to a cross-point button, with a maximum of 16
characters.
The specified source name appears on the display of the
cross-point control block or AUX bus control block.
There are six display modes, depending on the information
to display and format, switched using the display mode
buttons on the cross-point Flexi Pad.
For details about the display, see "Cross-Point Control
Block" (page 29) and "AUX Bus Control Block"
(page 46).
Note
When the [SHIFT] button is pressed to select the signal on
the shifted state of a button, the shifted signal name is
displayed.
Colors of lit cross-point buttons
In a particular row of cross-point buttons, only the last
pressed button is active, and is lit amber or red. Amber
indicates the "low tally" state and red indicates the "high
tally" state, indicating whether or not the selected signal
appears in the final output video.
State
Color of
button when lit
a)
Amber
Low tally
Red High tally
a) If secondary delegation mode is set on the AUX bus control block, the 4th
row buttons are lit green.
Cross-point indicators
This indicator is lit the same color (video signal source
color) as the buttons in the 3rd row of the cross-point
control block/AUX bus control block.
However, the color of the cross-point indicator does not
change even if a 3rd row button is lit red or amber.
Meaning
Does not appear in final
output video
Appears in final output video

Transitions

Transition Type

Type Description
Mix
The new video
progressively fades in
over the current video.
The sum of the two
video outputs is
maintained at a
constant, with the
output of each at 50%
at the mid-point of the
transition (i.e., when
the fader lever is in the
center position).
NAM The current video and
(non- new video signals are
additive compared, and the
mix) signal with the higher
luminance level is
given priority in the
output. The signals are
compared at the mid-
point of the transition
when both signals are
at 100%, at which point
the signal with the
higher luminance level
is output.
The current video is
Super
mix maintained at 100%
output for the first half
of the transition as the
new video is mixed
while increasing
progressively to 100%
at the mid point of the
transition.
Preset A color matte
color mix (unpatterned display) is
inserted during the
transition where the
current video is
switched to the new
video in a two-stage
transition.
Wipes A wipe switches from
the current video to the
new video using a
predetermined pattern.
DME
The current video
wipe switches to the new
video, similar to a wipe,
using a DME effect.
75
Independent See
key transitions page
–
Selectable
–
Not selectable
Not selectable
page
79
Not selectable
page
79
Selectable page
125
Selectable
page
138