Sony MVS-8000X User Manual page 153

- Channel 2: Since the priority is low, it will not be
visible on the screen, so no particular restrictions
apply.
In the Global Effect >Ch1-Ch2 >Combiner Priority
menu (4211), set the channel 1 priority higher when
setting the priority of channel 1 and channel 2.
• In the intermediate part of the transition, create the two
images so that both are visible within the screen. In the
Global Effect >Ch1-Ch2 >Combiner Priority menu
(4211), set the channel 1 priority higher when setting the
priority of channel 2 and channel 2.
It is recommended to make the priority settings at a
keyframe point at which the two images are not
overlapping.
• During the course of a transition, there is a dead zone
corresponding to the intermediate point of the whole
effect (see following figure), during which the image
does not change. Therefore, it is necessary to create the
effect so that the image in the intermediate part of the
transition is the keyframe for the mid-point of the whole
effect. The range of the dead zone corresponds to the
center one-third of the range of the transition indicator.
This also applies to an auto transition.
Keyframe effect
Last keyframe
Mid-point of effect
Change in image through transition
Image at point C
appears
Image at point B
appears (dead
zone)
Image at point A
appears
Transition indicator
• Create the last keyframe for each channel as follows.
- Channel 1: Since the priority is low, it will not be
visible on the screen, so no particular restrictions
apply.
- Channel 2: Create the image full-size.
• In the <Transition Mode> group of the Key Frame
>DME User PGM menu (6114), select [P In P].
First keyframe
Fader lever
152