Setting Source Names And Destination Names; Setting Flexi Pad Control Block Button Display And Operation; Setting The Button Operation Mode - Sony MVS-8000X User Manual

Setting Source Names and
Destination Names
You set the source and destination names to use in the
control panel.
Note
Before configuring these settings, it is necessary to set the
number of the S-Bus description name (see page 471).
1
In the <Source/Dest Name> group of the Engineering
Setup >Panel >Operation menu (7326), select the
name to use.
Sw'er Local: Source names set in the Xpt Assign
menu, and fixed bus names
S-Bus Descript: Description names set in the router.
S-Bus Type+Num: Type + Num set in the router
(display is a fixed eight characters).
2
In the <Name Display Mode> group, select the display
method.
Auto: Optimize display according to the number of
characters.
• 2-character 1-line display for two characters or
fewer
• 4-character 1-line display for four characters or
fewer
• 3-line display for 12 characters or fewer
• 4-line display for 16 characters or fewer
2 Character: The first two characters are displayed.
4 Character: The first four characters are displayed.
To replace a name set in the Xpt Assign menu
with an S-Bus description name
Press [S-Bus Name Link], turning it on.
When enabled, the source name is updated each time the
description name is updated on the router. This allows you
to always use the same description name between the
router and the switcher.
Even when [Sw'er Local] is selected, the same name can
be displayed when [S-Bus Descript] is selected. The S-Bus
description name is also displayed in the Xpt Assign menu.
Setting Flexi Pad Control Block
Button Display and Operation
In the Engineering Setup >Panel >Operation menu (7326),
press [Flexi Pad Mode] to open the Flexi Pad Mode menu
(7326.3).
Configure each function, as required.
Linking the transition type selection with the
Flexi Pad control block operation mode
Press [Wipe/DME Auto Deleg], turning it on.
This switches the operation mode of the Flexi Pad control
block in sync with the selection of the [WIPE] button or
[DME WIPE] button on the transition control block.
Setting the memory recall button display in wipe
snapshot operation mode and DME wipe
snapshot operation mode
In the <Wipe/DME Display> group, set one of the
following.
Pattern: Pattern image display
Register Name: Register name display
Setting the memory recall button display in
snapshot operation mode and effect operation
mode
In the <Snapshot/Effect Display> group, set one of the
following.
Register No: Register number display
Register Name: Register name display

Setting the Button Operation Mode

In the Engineering Setup >Panel >Operation menu (7326),
press [Custom Button] to open the Custom Button menu
(7326.4).
Configure each function, as required.
Setting the double-press operation mode of the
[BKGD] button in the transition control block
In the <Bkgd Trans Btn Double Clk> group, select one of
the following.
Disable: When the [BKGD] button is pressed twice in
quick succession, all currently inserted keys are
selected and removed by the next transition.
Enable: Double-pressing of the [BKGD] button is
disabled.
Setting the operation mode when the [FTB]
button is pressed during fade-to-black
In the <FTB> group, select one of the following.
Continue: Continue the fade-to-black.
Cancel: Cancel the fade-to-black, and return to the
previous state.
Setting the operation mode when the [AUTO
TRANS] button is pressed during an auto
transition
In the <Auto Trans/Take> group, select one of the
following.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition, and return to the
previous state.
428