Sony MVS-8000X User Manual page 397

- 1080P: 1 frame (2 frames in 1080P signal format) with
respect to the reference signal
Supported conversion format
combinations
The combinations of switcher signal formats and
supported format converter formats are as follows.
Note
When the signal format is 1080PsF/23.98 or 1080PsF/24,
the format converter cannot be used.
Switcher Signal formats supported by format
signal converter
format
a) b)
Inputs
FC Input 1 to 4 /
5 to 8 / 9 to 12 / 13 to
16
720P/59.94
480i/59.94
1080i/59.94
1080PsF/29.97
720P/50
576i/50
1080i/50
1080PsF/25
720P/50 576i/50
576i/50 (with FS)
1080i/50
480i/59.94
720P/59.94
480i/59.94 (with FS)
1080i/59.94
576i/50
1080i/50
576i/50 (with FS)
720P/50
1080i/59.94 480i/59.94
480i/59.94 (with FS)
720P/59.94
1080PsF/25 576i/50
1080PsF/ 480i/59.94
29.97
1080P/50 1080i/50
1080P/59.94 1080i/59.94
a) FC Input 9 to 12 and FC Input 13 to 16: MVS-8000X only
b) When the switcher signal format is 1080P, the supported inputs are FC
Input 1, 3, 5, 7, 9, 11, 13, and 15 only (9, 11, 13, and 15 on the MVS-
8000X only).
c) Output signals converted from 720P or 1080P are not synchronized to the
reference signal. On the destination device, use an operation mode that can
sync to the format converter output signal without using an external
reference signal.
Setting the conversion format
1
Open the Engineering Setup >System >Format menu
(7313).
Outputs
FC Output 1, 2 / 3, 4
2
720P/59.94
1080i/59.94
1080PsF/29.97
720P/50
1080i/50
1080PsF/25
c)
576i/50
c)
1080i/50
c)
480i/59.94
c)
1080i/59.94
576i/50
720P/50
480i/59.94
720P/59.94
3
576i/50
480i/59.94
4
c)
1080i/50
c)
1080i/59.94
5
6
7
8
9
395
Current settings of format converter
Press [Format Converter].
The Format Converter menu (7313.4) appears.
To set the conversion format for SWR1 FC Input 1 to
4, press [Input 1-4 Format] in the <SWR1 FC Input>
group.
Select the input signal format in the pop-up window.
Refer to steps 3 and 4 to select the input signal format
for [Input 5-8 Format], [Input 9-12 Format], and [Input
13-16 Format].
To set conversion format for SWR1 FC Output 1 and
2, press [Output 1-2 Format] in the <SWR1 FC
Output> group.
Select the output signal format in the pop-up window.
Refer to steps 6 and 7 to select the output signal format
for [Output 3-4 Format].
Configure settings for SWR2 in the same way as
required.