Sony MVS-8000X User Manual page 318

Transition First transition Transition
start
completion
point
Effect execution
Image created by interpolation
Background A
Background B
At the first transition completion point, if you move the
image with the positioner, the transition appears as
follows.
Transition start First transition
completion
point
Image created by interpolation
Background A
Background B
State before modification
Signals forming part of the background for
a DME wipe
For a 2-channel mode page turn, roll, brick, frame in-out,
and so on, the part of the pattern image shown in gray is
filled with the signal selected on the DME external video
bus.
end
For 3-channel mode brick, the part of the pattern image
shown in dark gray is filled with the DME external video
signal, and the light gray portion with the signal selected as
follows.
For details about patterns, see "DME Wipe Pattern List"
(page 481).
For a DME dedicated interface
• When the DME channel used is 3 or 4, the signal
• When the DME channel used is 7 or 8, the signal
For a DME SDI interface
Signal selected on the AUX bus assigned in the
Engineering Setup >Switcher >Device Interface >DME
Type Setting >DME SDI I/F menu (7337.7). The AUX bus
is determined by which DME channel is being used.
For the SDI interface on the DME, in some cases the AUX
bus is used in place of the DME external bus.
For details, see "Setting the Interface Between the DME
and the Switcher" (page 455).
Transition
end
Setting the transition mode
1
2
Effect execution
317
selected on the DME utility 1 bus.
selected on the DME utility 2 bus.
Note
Open the Key Frame >DME User PGM menu (6114).
In the <Transition Mode> group, select the transition
mode according to the DME wipe action.
Single: Select single transition mode.
Flip Tumble: Select flip tumble transition mode.
Dual: Select dual transition mode.
P in P: Select picture-in-picture mode.
Compress: Select compress mode.
Frame I/O: Select frame in-out transition mode.
Frame I/O H: Select frame in-out transition mode in
the horizontal direction.
Frame I/O V: Select frame in-out transition mode in
the vertical direction.
For details about user programmable DME, see
"Creating User Programmable DME Patterns"
(page 150).
Note
The DME channel selected as the reference region (lit
green) in the numeric keypad control block is reflected
in the <Transition Mode> group display.