Swirl Settings; Melt Settings - Sony MVS-8000X User Manual

No. Parameter Adjustment
3 Spiral
Degree of curvature of transition
path
When [Rectangle], [Star], [Heart], or [Ellipse] is
selected
No. Parameter Adjustment
1 Transition Degree of transition
2 Curve
Degree of image periphery
expansion
3 Aspect Aspect ratio of waveform
4 Angle Slant of waveform
To turn the fragments into stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Density Degree to which image disappears
2 Random Degree of randomness in flying
fragments
To set the explosion center point
1
Press [Position].
2
Set the following parameters.
No. Parameter Adjustment
1 H Center point in horizontal direction
2 V Center point in vertical direction

Swirl Settings

You can set the amount of swirl, the swirl region, the
amount of rotation, and the swirl center position.
Applying the Swirl effect
In the Non Linear >Swirl menu (4141.26), set the
following parameters.
No. Parameter Adjustment
1 Transition Swirl amount
2 Center Amount of rotation in center of swirl
3 Outer Amount of rotation outside of Area
4 Area Region of swirl
To turn the tip of the swirl into stardust
1
Press [Pixel], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Density
2 Random
To set the center position of the swirl
1
Press [Position].
2
Set the following parameters.
No. Parameter Adjustment
1 H
2 V

Melt Settings

You can set the degree of transition, the degree of
extension in the image, the jaggedness of the melting
sections, the amplitude and frequency, amount of
movement, the speed of the melting sections, the slant of
the borders, the shape of the sections that begin to melt,
and other parameters.
Applying the Melt effect
1
In the <Direction> group of the Non Linear >Melt
menu (4141.27), select the melt method.
Up: Melting occurs upward.
Down: Melting occurs downward.
2
To make transition settings, press [Transition] and set
the following parameters.
No. Parameter Adjustment
1 Transition
2 Curve
3 Random
3
To make wave settings for the melting part, press
[Border] and set the following parameters.
No. Parameter Adjustment
1 Amp
2 Freq
a)
Offset
3
b)
4 Speed
5 Slant
257
Degree to which image disappears
Trail type and amount of stardust
Horizontal center position of swirl
Vertical center position of swirl
Degree of transition
Degree to which image stretches
Degree of jaggedness at melted
part
Amplitude of wave
Frequency of wave
Wave phase shift offset
Direction of travel and speed of
wave
Slant of border