Setting Wipe Modifiers - Sony MVS-8000X User Manual

When morphing is selected
No. Parameter Adjustment
2 Start
Point in transition at which main
pattern is at 100%
3 End Point in transition at which sub
pattern is at 100%
6
In the <Main/Sub Link> group, configure the main/
sub modifier link.
Full: Full link mode
Semi: Semi link mode
Applying a diamond dust wipe effect to the
selected pattern
1
In the M/E-1 >Wipe >Pattern Mix menu (1152), press
[Dust Mix], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
1 Mix Ratio Mix level of diamond dust pattern
2 H Size Particle width
3 V Size Particle height
4 Flash Rate Rate of generation of particles

Setting Wipe Modifiers

You can apply various modifiers to a wipe pattern, such as
setting the wipe direction and pattern position.
Note that some modifiers may not be available, depending
on the pattern (see page 134).
Main pattern and sub pattern modifiers
You can set the following modifiers independently for the
main pattern and sub pattern.
• Positioner
• Rotation
• Aspect
• Multi
• Pairing
• Modulation
• Spring
• Spiral
Modifiers for the main pattern are set in the M/E-1 >Wipe
>Main Modify menu (1155), and modifiers for the sub
pattern are set in the M/E-1 >Wipe >Sub Modify menu
(1156). The menu operations are common to both.
This section describes setting modifiers for the main
pattern as an example.
Setting the wipe direction (Direction)
Specify the direction of the wipe effect.
Normal
Reverse
Normal/Reverse
The wipe direction alternates between normal and reverse
after each transition.
To specify the wipe direction in the menu
1
Open the M/E-1 >Wipe >Edge/Direction menu
(1154).
2
In the <Direction> group, specify the wipe direction.
To specify the wipe direction using a button in the
transition control block
In the transition control block of each bank, press the wipe
direction selection buttons.
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
Splitting the wipe pattern (Split)
This splits the pattern, making the parts of the wipe move
in opposite directions.
Split disabled
1
Open the M/E-1 >Wipe >Edge/Direction menu
(1154).
2
Press [Split], turning it on.
3
Set the following parameters.
128
Wipe in the normal direction.
Wipe in the opposite direction of
the normal direction.
Split enabled