Applying Special Effects (Common Operations); Applying Special Effects (Edge Effects); Border Settings - Sony MVS-8000X User Manual

Applying Special Effects
(Common Operations)
This section describes the operation of each effect using
the setup procedure in the DME menu.
Select the DME channel in the device control block
(trackball) before operating the menu.
1
Press the [DME] button on the device control block.
2
Using the channel selection buttons, select the target
channel (CH1 to CH8) of the operation.
3
Configure each effect in the DME menu.
Applying Special Effects
(Edge Effects)

Border Settings

Adding a border
1
Open the DME >Edge >Border/Crop menu (4111).
2
Press [Border], turning it on.
3
Set the following parameters.
Parameter group [1/2]
No. Parameter Adjustment
1 H
2 V
3 All
5 Density
No. Parameter Adjustment
1 Top
2 Left
3 Right
4 Bottom
5 Density
Selecting the border color
Set the border color in the Border/Crop menu (4111).
The operation differs depending on the DME used (MVE-
8000A, MVE-9000 or MKS-7470X/7471X).
When the MVE-8000A is used
Press [Border Color] and set the following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
When the MVE-9000 or MKS-7470X/7471X is used
In the <Border Fill> group, select the signal to insert in the
border.
Flat Color: Single color
227
Simultaneously adjust border width
of left and right edges
Simultaneously adjust border width
of top and bottom edges
Simultaneously adjust border width
on all edges
Border density
Parameter group [2/2]
Border width on top side
Border width on left side
Border width on right side
Border width on bottom side
Border density
Adjustment
Luminance
Saturation
Hue