Setting a Cross-Point
Control Block/AUX Bus
Control Block
Setting a Button Row in a Cross-
Point Control Block
Setting the operation mode of a button
row
You can set the operation mode of a cross-point button
row in the cross-point control block.
For details about operation modes, see "Operation Mode
of a Button Row" (page 83).
Note
When a switcher bank is shared on main and sub in multi
program 2 mode, the operation mode of main and sub
button rows are linked.
1
Open the Home > Setup > Panel > Xpt Module >
Operation Mode menu (19104.31).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
3
In the [Row Mode] group, select an operation mode.
Key Bus: Key bus mode
Free Assign: Free assign mode
Key Deleg/AUX: Key/AUX bus delegation mode
Setting a button row in free assign mode
In free assign mode, you can assign a bus or utility/
shotbox mode bank to the 1st row to 4th row.
Note
You can also set the 1st row to 4th row using delegation
buttons assigned to the cross-point pad/function button
section.
For details, see "Bus Types and Assignments" (page 84).
1
Open the Home > Setup > Panel > Xpt Module > Free
Assign menu (19104.32).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
A list of button rows is shown on the left and a list of
assignable buses/banks is shown on the right.
3
In the list on the left, select the target button row (1 to
4) to set.
4
In the list on the right, select a bus/bank to assign.
5
Press the [Set] button.
To return the assignment to the defaults
Press the [Default Recall] button, check the message, then
press [OK].
Setting the key/AUX bus delegation mode
button row
You can assign bus or utility/shotbox mode bank
delegation buttons to the 1st row in key/AUX bus
delegation mode.
1
Open the Home > Setup > Panel > Xpt Module > Key
Deleg/AUX Assign menu (19104.33).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
A list of 1st row button numbers is shown on the left
and a list of assignable buses/banks is shown on the
right.
3
In the list on the left, select the target button number
to set.
4
In the list on the right, select a bus/bank to assign.
5
Press the [Set] button.
To return the assignment to the default
Press the [Default Recall] button, check the message, then
press [OK].
Setting a Button Row in an AUX Bus
Control Block
You can set delegation button rows (1st row/2nd row) in
an AUX bus control block (AUX bus operation mode).
Note
When using two AUX bus control blocks, the button row
settings are common to both.
403