Setting Dme Wipe Modifiers - Sony MVS-8000X User Manual

c) The vertical center position of the video pasted on Side H. At –100.00, the
center is at the bottom edge of the screen. At +100.00, the center is at the
top edge of the screen.

Setting DME Wipe Modifiers

You can apply various modifiers, such as setting the wipe
direction or the pattern position.
For an overview of modifiers and supported pattern
numbers, see "DME Wipe Pattern Variation and
Modifiers" (page 141).
Specifying the DME wipe direction
(Direction)
You can specify the DME wipe direction (normal/reverse).
To specify the wipe direction in the menu
1
Open the M/E-1 >DME Wipe >Edge/Direction menu
(1164).
2
In the <Direction> group, specify the DME wipe
direction.
Normal: DME wipe in the normal direction.
Normal/Reverse: DME wipe in the normal and
reverse direction alternately for each transition.
Reverse: DME wipe in the opposite direction to
normal.
To specify the DME wipe direction with a button
in the transition control block
In the transition control block of each bank, press the wipe
direction selection buttons.
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
Modifying a DME wipe pattern edge (Edge)
1
Open the M/E-1 >DME Wipe >Edge/Direction menu
(1164).
2
In the <Ch Select> group, select the target channels.
For a pattern in 1-channel mode: Select [1st Ch].
For a pattern in 2-channel mode or 3-channel
mode: Select the corresponding channels. You
can select more than one channel at the same time.
3
In the <Edge> group, select the edge type.
Border: Border
Soft Border: Soft border
4
Depending on the selection in step 3, set the following
parameters.
When [Border] is selected
No. Parameter Adjustment
1 Width
3 Luminance Luminance of border color
4 Saturation
5 Hue
When [Soft Border] is selected
No. Parameter Adjustment
1 Width
2 Inner Soft
3 Luminance Luminance of border color
4 Saturation
5 Hue
Display indications when multiple channels are
selected at the same time
The parameter setting value display shows the settings
of the lowest-numbered channel. When you adjust the
settings, this adjusts the settings on the other channels
by the same amount.
Setting the DME wipe pattern position
(Positioner)
1
Open the M/E-1 >DME Wipe >Modify menu (1165).
2
In the <Ch Select> group, select the target channels.
For a pattern in 1-channel mode: Select [1st Ch].
For a pattern in 2-channel mode: Select the
corresponding channels. You can select more than
one channel at the same time.
3
In the <Position> group, press [Position], turning it on.
4
Set the following parameters.
No. Parameter Adjustment
1 H
2 V
Display indications when multiple channels are
selected at the same time
The parameter setting value display shows the settings
of the lowest-numbered channel. When you adjust the
settings, this adjusts the settings on the other channels
by the same amount.
144
Border width
Saturation
Hue
Border width
Degree of softness inside the
border
Saturation
Hue
Horizontal position
Vertical position