Frame Memory Clip Function - Sony MVS-8000X User Manual

Frame Memory Clip
Function
Frame memory clips
Movies can be read into frame memory, and recalled and
played back. A movie held in frame memory is called a
"frame memory clip."
A frame memory clip can be named using up to four
characters (see page 161)
.
Ancillary data
In a frame memory clip, in addition to the video image,
you can also record and play back ancillary data which can
be used as embedded audio.
To record ancillary data, the frame memory saving mode
must be set to "save with ancillary data" in the Setup menu.
For details, see "Registering a Frame Memory Clip with
Ancillary Data" (page 404).
Notes
• When saving with ancillary data is enabled, the saving
mode for still images also changes to "save with
ancillary data," but when playing back a still image the
ancillary data is never played.
• When you change the saving mode, the frame memory is
initialized, and all existing recorded frame memory data
is lost.
• When the signal format is 1080P, ancillary data is not
supported.
Note on transferring ancillary data
Ancillary data is recorded when the frame memory saving
mode is set to "save with ancillary data." It can be saved to
a local drive or an external storage device, such as a
removable drive, and then recalled. However, the ancillary
data can only be saved or recalled in the following
circumstances.
• When the frame memory saving mode is set to "save
with ancillary data."
• When ancillary data is present in the saved or recalled
frame memory file.
• When the system signal format is the same as the signal
format in the file.
When the frame memory saving mode is set to "save with
ancillary data," the following ancillary data status
information is added to a frame memory clip.
• Disable:
In this state, the ancillary data is not played. This is the
status when [Ancillary Enable] is not lit in the Frame
Memory >Clip >Ancillary Enable menu (2525).
• Enable:
In this state, ancillary data is present, and can be played
back. This is the status when [Ancillary Enable] is lit in
the Frame Memory >Clip >Ancillary Enable menu
(2525). This is the status after a clip recording operation.
The status information is saved in a file, and the recalled
file is reproduced based on this information.
Frame memory clip settings
For frame memory clips, you can make the following
settings in the menu or device control block (trackball).
• Start point
• Stop point
• Loop
The above settings can be saved in a snapshot register as
snapshot attributes, and then recalled.
163