Switcher; Settings Relating To Device Management; Setting The Date And Time; Using A Removable Drive - Sony MVS-8000X User Manual

Notes
• When the MKS-7470X/7471X is used, this setting is
fixed to [3G Mode].
• When [Dual Link Mode] is selected, half as many
DME units can be connected to the switcher. In this
case, the available channels are DME1 channels 1
and 2, and DME2 channels 3 and 4.
• When [Dual Link Mode] is selected, you cannot use
a the MVE-8000A connected via an SDI interface.
3
Press [Execute].
4
Check the message, then press [Yes].
Setting the Number of DMEs to
Connect to the Switcher
If a 3rd DME (DME3) and 4th DME (DME4) are not
connected and the signal format is 1080P, the maximum
number of control panels that can be connected to the
switcher can be increased from two to four.
To change the number of control panels that can be
connected, it is necessary to set the number of DME units
to connect to each switcher.
Notes
• This setting is available only when the signal format is
1080P.
• If the number of DMEs connected is two, the maximum
number of control panels that can be connected is four.
If the number of DMEs connected is four, the maximum
number of control panels that can be connected is two.
1
In the Engineering Setup >System >Install/Unit
Config menu (7316), select SWR1 and press [Unit
Config].
The Unit Config menu (7316.8) appears.
2
In the <Max Number of DME> group, select the
number of DMEs to connect.
2 units: Sets the maximum number of DMEs to two.
4 units: Sets the maximum number of DMEs to four.
3
Press [Execute].
4
Check the message, then press [Yes].
Settings Relating to
Device Management

Setting the Date and Time

1
In the Engineering Setup >System >Maintenance
menu (7317), set the following parameters.
No. Parameter
1 Hour
2 Min
3 Sec
No. Parameter
1 Month
2 Day
3 Year
The specified date and time appear in the "Set" field in
the status area.
2
Press [Set Date/Time].
This sets the current time to the date and time set in
step 1, and changes the "Current" field in the status
area.

Using a Removable Drive

Displaying removable drive information
1
Connect a removable drive to the DEVICE connector
of the menu panel.
2
In the <USB Storage Device> group of the
Engineering Setup >System >Maintenance menu
(7317), press [Refresh].
Initializing a removable drive
Note
Format a commercially available removable drive before
using it for the first time.
1
Connect a removable drive to the DEVICE connector
of the menu panel.
405
Parameter group [1/2]
Adjustment Setting
Hour 0 to 23
Minute 0 to 59
Second 0 to 59
Parameter group [2/2]
Adjustment Setting
Month 1 to 12
Day 1 to 31
Year 2000 to 2037