Power-On (Startup) State Selection - Sony MVS-8000X User Manual

4:3: Set the screen aspect ratio to 4:3.
Independ: Set the screen aspect ratio separately for
M/E, P/P, and User on the switcher, and for each
channel on the DME.
3
When [Independ] is selected in step 2, select one of the
following.
Switcher Aspect: Set the aspect ratio for the switcher.
DME Aspect: Set the aspect ratio for the DME.
4
Perform the following operations, according to the
selection in step 3.
When [Switcher Aspect] is selected: In each of the
<M/E-1>, <M/E-2>, <M/E-3>, <M/E-4>, <P/P>,
and <User> groups, select [16:9] or [4:3].
When [DME Aspect] is selected: In each of the
<CH1> to <CH4> groups, select [16:9] or [4:3].
5
Press [Aspect Execute].
6
Check the message, then select [Yes].
Power-On (Startup) State
Selection
This sets the initial state of each device when the system is
powered on.
Select Resume mode or Custom mode for each device.
Resume mode
This resumes operation with the state in force when the
power was last turned off. This setting is only available for
the switcher and control panel.
Custom mode
This mode uses settings saved in non-volatile memory or
ROM within each device.
You can set Setup mode and Initial Status mode settings
separately.
• Setup mode: Set one of the following setup states to use
after powering on.
User: Start up using the user data previously saved with
[Setup Define].
Factory: Start up with the factory default settings.
• Initial Status mode: Set one of the following states of
each device after powering on (excludes Setup mode
settings).
User: Start up using the user data previously saved with
[Initial Status Define].
Factory: Start up with the factory default settings.
For details, see "Saving and Recalling Setup Data"
(page 398).
Autoload function
This function automatically loads preset register data or
frame memory image data when powering on. The data to
load is configured in the File menu.
397