Advertisement
Note
The recalled settings information may vary
depending on the recall mode setting saved in the
register.
For details, see "Setting the key snapshot recall
mode" (page 147).
To undo a register recall
To undo a recall immediately after recalling a register,
press the [UNDO] button.
Key Snapshot Operations (Menu)
The same memory recall buttons as in the memory recall
section of the Flexi Pad control block are displayed in the
Key Snapshot menu for each key of the switcher bank.
The settings and display of the memory recall buttons in
the Flexi Pad control block and in the menu are linked.
This section describes the M/E-1 key 1 menu as an
example.
Saving a key snapshot
Set a key and save a key snapshot register using the
following procedure.
1
Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2
Press the [Store] button in the [Mode] group.
3
Press the button for the target register to save.
The register button is lit orange and the key settings
are saved in the snapshot.
Note
If you press a register button in which a key snapshot
is already saved, the register data will be overwritten.
Setting the key snapshot recall mode
You can select the settings information to recall in a key
snapshot and save it for each register.
1
Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2
Press the button for the target register to set.
3
In the [Recall Mode] group, select a recall mode.
You can select multiple buttons.
Xpt: Recall cross-point selection information for a
key.
Modifier: Recall modifier settings information for a
key.
Transition: Recall settings information for an
independent key transition.
Recalling a key snapshot
1
Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2
Press the [Recall] button in the [Mode] group.
3
Press the button for the target register to recall.
The register button is lit orange and the key snapshot
is recalled.
Deleting a key snapshot
Note
A locked register cannot be deleted.
1
Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2
Press the [Delete] button in the [Mode] group.
3
Press the button for the target register to delete.
The key snapshot is deleted and the register button
changes to register number display.
Renaming a key snapshot register
Note
A locked register cannot be renamed.
1
Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2
Press the [Rename] button in the [Mode] group.
3
Press the button for the target register to rename.
The [Rename] window appears.
4
Press the input field and enter a name (up to 8
characters) using the keyboard.
5
Press [OK].
147
Advertisement
Chapters
