Key Snapshots; Key Snapshot Operations (Flexi Pad Control Block); Key Snapshot Operations (Menu) - Sony XVS-G1 User Manual

Key Snapshots

You can save key settings (excluding key inserted/
removed (on/off) status and key priority) in a register and
recall the settings when required. Settings information of
cross-points, key modifiers, and independent key
transitions can be selected and recalled. There are four key
snapshot registers for each key.
For details about editing a key snapshot register, see "Key
Snapshot Register Operations" (page 225).
Saving and recalling a key snapshot can be performed
using the Flexi Pad control block or the menu.
Key Snapshot Operations (Flexi Pad
Control Block)
You can configure a key snapshot using the Flexi Pad
control block of the target switcher bank.
This section describes setting a key snapshot on key 1 as
an example.
Memory recall section in key snapshot operation
mode
Pressing the [KEY] button in the Flexi Pad control block
switches the memory recall section to key operation mode.
You can select key snapshot registers (1 to 4) using the
buttons in the memory recall section.
The register name is displayed on buttons for registers with
a registered snapshot.
The register number is displayed on buttons for registers
without a registered snapshot.
The button color varies as follows, according to the
register state.
Gray characters: Register not containing a registered
snapshot
White characters: Register containing a registered
snapshot
Lit orange: Last recalled register
Saving a key snapshot
Set a key and save a key snapshot register using the
following procedure.
1
Press the [KEY] button.
The memory recall section switches to key operation
mode.
2
Press the [KEY1] button.
3
Press and hold the [KEY] button and press the button
for the target register to save.
The register button is lit orange and the key settings are
saved in the snapshot.
Note
If you press a register button in which a key snapshot
is already saved, the register data will be overwritten.
Recalling a key snapshot
1
Press the [KEY] button.
The memory recall section switches to key operation
mode.
2
Press the [KEY1] button.
3
Press the button for the target register to recall.
The register button is lit orange and the key snapshot
is recalled.
Note
The recalled settings information may vary depending
on the recall mode setting saved in the register.
For details, see "Setting the key snapshot recall
mode" (page 97).
Deleting a key snapshot
1
Press the [KEY] button.
The memory recall section switches to key operation
mode.
2
Press the [KEY1] button.
3
Press and hold the [DEL] button and press the button
for the target register to delete.
The key snapshot is deleted and the register button
changes to register number display.

Key Snapshot Operations (Menu)

The same memory recall buttons as in the memory recall
section of the Flexi Pad control block are displayed in the
Key Snapshot menu for each key of the switcher bank. The
settings and display of the memory recall buttons in the
Flexi Pad control block and in the menu are linked.
This section describes the M/E-1 key 1 menu as an
example.
96