Knob Parameter Adjustment
4
Dust
Aspect
a) The way in which the afterimage disappears is affected by both
Decay and Trail Dust parameter adjustments.
Setting a combine process
Select whether to add the Trail effect before or after the
combine.
Notes
• The combine process function is not supported on the
MVE-8000A.
• When you change the selection in the <Combine
Process> group, the afterimages which had been added
up to then disappear.
• When you do not combine images, the Trail effect only
is applied, regardless of the selection in the <Combine
Process> group.
Select one of the following in the <Combine Process>
group.
Combine –> Trail: Add the Trail effect after the combine.
As the trail parameters, the data for the channel with
the lowest number among the channels being
combined is enabled.
Trail –> Combine: Add the Trail effect before the
combine. Trails parameters can be set independently
for each channel.
Combine –> Trail
Motion Decay Settings
Notes
When you turn on motion decay, if the Trail, Keyframe
Strobe or Wind effect is on, it automatically goes off.
Blurring image motion
1
In the DME menu, select VF5 'Light/Trail' and HF3
'Motion Decay.'
The Motion Decay menu appears.
284
Applying Special Effects (Lighting and Recursive Effects)
Setting values
Aspect ratio
–100.00 to +100.00
of stardust
Trail –> Combine
2
Press [Motion Decay], turning it on.
3
Set the following parameter.
Knob Parameter Adjustment
1
Video
Degree of
Decay
blurring of the
video signal
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the
afterimage does not decay.
4
In the <Decay Mix Mode> group, select the way in
which the video signal is blurred.
Soft: mix the live image and the afterimage.
Hard: show the lighter of the live image and
afterimage.
5
To erase the afterimage, press [Decay Eraser], turning
it on.
Erasing the afterimages that remain in
memory whenever a keyframe is passed
Press [Decay Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
Selecting the freeze timing
In the <Decay Freeze Timing> group, select the timing for
motion decay freezing.
Frame: freeze in frame units.
Field: freeze in field units.
Notes
The freeze timing setting is not required when the
following signal formats are being used.
1080P/50, 1080P/59.94, 1080PsF/23.976,
1080PsF/24, 1080PsF/25, 1080PsF/29.97, 720P/
50, 720P/59.94
Applying stardust to the afterimage
portion
The afterimage portion becomes stardust, and gradually
disappears.
1
Press the [DUST] button, turning it on.
2
Set the following parameters.
Knob Parameter Adjustment
1
Decay
Amount of the
Dust
afterimage
disappearing as
stardust
Setting values
a)
0.00 to 100.00
Setting values
0.00 to 100.00
a)