Set Chassis Usb Validity - Hitachi Compute Blade 500 Series User Manual

Example
[Displays Default Physical MAC address which the card installed on server
blade 0 is using. ]
$ show mac original -b 0
-- Original MAC List --
Slot
Card
----------- --- ---------- ---- ------------------
mezzanine
mezzanine
mezzanine
mezzanine
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
When you specify -p parameter and a non-primary server blade in SMP
configuration, the following message appears without showing MAC address.
E0640 : <Blade %1$d> Command was canceled. Specified blade is not the
primary blade of SMP.

set chassis usb validity

Command
set chassis usb validity -p <usb_port> -v <validity> [-F]
Description
Enables or disables a USB port on the front panel.
Role
Chassis
Parameters
-p <usb_port>
Port number of usb
-v <validity>
Enabled or disabled usb ports
-F
2-18
: 0
Num Controller Port MAC address
1
1
1
1
Range is from 0 to 1.
enable : Enabled.
disable : Disabled.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
0 0 00:00:87:b8:65:90
0 1 00:00:87:b8:65:91
0 2 00:00:87:b8:65:92
0 3 00:00:87:b8:65:93