Good Read When To Indicate - Datalogic Magellan 8300 Product Reference Manual

Good Read When to Indicate

NOTE
Product Reference Guide
This feature specifies when the scanner will provide indication (beep
and/or flash its green LED) upon successfully reading a bar code.
• Good Read = Indicate after decode
• Good Read = Indicate after transmit
• Good Read = Indicate after CTS goes inactive, then active
The "Indicate after CTS goes inactive..." mode applies to RS-232 STD
and RS-232 WN interfaces only. If set to this mode in other interfaces,
"Indicate after decode" mode will be implemented.
To set the Good Read When to Indicate feature:
1. Scan the SWITCH bar code.
2. Scan the desired mode bar code from this page. You'll need to
cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to
scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
GOOD READ = INDICATE AFTER DECODE
Indication Features
135