Table of Contents
Advertisement
INSTALLATION – DS8100 SERIAL INTERFACE
2.2
OPENING THE SCANNER
Before installing the DS8100 Serial Interface model, it may be necessary to open the
scanner to select the Main interface type and the Multidrop Address (see par. 2.2.1
and 2.2.2).
Before unscrewing the display panel of the DS8100, make sure
the power supply cable is disconnected to avoid shock or harm to
the operator.
The following operation should be performed by qualified
WARNING
personnel only.
Refer to the following instructions and Figure 6 when opening the reader:
1-
The part of the device to be opened is the display panel.
2-
Unscrew the six screws to open the scanner.
3-
Carefully remove the panel as shown in Figure 6:
Figure 6 - Opening the DS8100
2
9
Advertisement
Table of Contents
