Radwin 5000 HPMP User Manual page 90

Using the Map View

To relocate a HBS or HSU by setting latitude and longitude coordinates:
1. Right click the HBS (Bach@HBS.01) to open its Context menu and then Configure.
2. Click the Coordinates button to open the Coordinates window and enter the required
latitude and longitude.
You may enter the coordinates in decimal or degrees/minutes/seconds using the
input template shown below:
3. HBS only: The Azimuth and Beam Width determine the sector center‐line direction
and angle They are only used for initial default distribution of HSUs on the map.
4. Click OK. The unit is moved to the new location (possibly off‐screen).
5. Repeat the previous four steps for each HSU in the sector. If at the end of the process,
the HBS is off‐screen, click the Center on Sector button to "fly" to the sector.
Using the example in Table
RADWIN 5000 HPMP User Manual
5‐7, here is the outcome:
Release 3.5.70 5‐21